ARM STM/i.MX: Add the reset control of LCD
Subsystems (4)
PATCH 4/4 ARM STM/i.MX: Add the reset control of LCD
Video controller of STM allow to control the reset bit of an external LCD controller. When reset_lcd is set, CTRL1_RESET bit is used to enable and disable LCD.
Signed-off-by Gregory CLEMENT <[email protected]>
--- arch/arm/mach-stm/include/mach/fb.h | 1 + drivers/video/stm.c | 11 +++++++++++ 2 files changed, 12 insertions(+), 0 deletions(-)
arch/arm/mach-stm/include/mach/fb.h +1 -0
@@ -39,6 +39,7 @@ struct imx_fb_videomode {unsigned ld_intf_width;/**< refer STMLCDIF_* macros */ unsigned data_mode;u32 bits_per_pixel; + unsigned reset_lcd; /** use LCD_RESET signal*/ };#endif /* __MACH_FB_H */
drivers/video/stm.c +11 -0
@@ -48,6 +48,7 @@# define CTRL1_FIFO_CLEAR (1 << 21)# define SET_BYTE_PACKAGING (x) (((x) & 0xf) << 16)# define GET_BYTE_PACKAGING (x) (((x) >> 16) & 0xf) +# define CTRL1_RESET (1 << 0)#ifdef CONFIG_ARCH_IMX28 # define HW_LCDIF_CTRL2 0x20
@@ -271,6 +272,11 @@ static void stmfb_enable_controller(struct fb_info *fb_info)/* stop FIFO reset */ writel (CTRL1_FIFO_CLEAR , fbi->base +HW_LCDIF_CTRL1 +BIT_CLR ); + +/* enable LCD using LCD_RESET signal*/ +if (fbi->pdata->reset_lcd) +writel (CTRL1_RESET , fbi->base +HW_LCDIF_CTRL1 +BIT_SET ); +/* start the engine right now */ writel (CTRL_RUN , fbi->base +HW_LCDIF_CTRL +BIT_SET ); }
@@ -281,6 +287,11 @@ static void stmfb_disable_controller(struct fb_info *fb_info)unsigned loop;uint32_t reg; + +/* disable LCD using LCD_RESET signal*/ +if (fbi->pdata->reset_lcd) +writel (CTRL1_RESET , fbi->base +HW_LCDIF_CTRL1 +BIT_CLR ); +/* * Even if we disable the controller here, it will still continue * until its FIFOs are running out of data
Signature · 8 lines
1.7.0.4 _______________________________________________ barebox mailing list [email protected] http://lists.infradead.org/mailman/listinfo/barebox