Skip to contentSkip to conversation

Join play of pcm in multiple playback devices

DISCUSSION Irfan shaikh 2 participants 2 messages Jan 3, 2012

lore
Share & tools
lore
#0 lore raw

Hello All,

I have written an application which supports join play of
PCM Audio.
i.e Capture and write to playback device 1 and playback device 2 simultaneously.

Below code is just to explain the above scenario :

/######################/

while(1)

{
     retval=snd_pcm_readi(pAlsaConfig->pcm_handle, buffer, 
pAlsaConfig->alsaBufferSize);
     snd_pcm_writei(pAlsaConfig->pcm_handle1, buffer,retval);
     snd_pcm_writei(pAlsaConfig->pcm_handle2, buffer,retval);
}

/######################/

In above case, renderer 2 lags behind the renderer 1 i.e there is delay between two audio devices when actually heard.

Please help me if some better implementation for join play. I have seen some thing as snd_pcm_link(). But i was not clear with its usage, while doing snd_pcm_writei ???

Thanks and regards,
Irfan

#1 lore raw
Quoted 7 lines

while(1)

{
      retval=snd_pcm_readi(pAlsaConfig->pcm_handle, buffer,
pAlsaConfig->alsaBufferSize);
      snd_pcm_writei(pAlsaConfig->pcm_handle1, buffer,retval);
      snd_pcm_writei(pAlsaConfig->pcm_handle2, buffer,retval);
}

This code doesn't work in the general case where the different devices don't share a common audio clock and have different physical capture/playback rates. Compensating for clock drift requires the use of asynchronous sample-rate conversion.
Assuming you have a perfectly synchronous system, you could make use of snd_pcm_delay() to compensate for delays incurred in the driver/firmware/hardware. This is not well supported by all drivers though. -Pierre