Join play of pcm in multiple playback devices
Hello All,
I have written an application which supports join play of
PCM Audio.
i.e Capture and write to playback device 1 and playback device 2 simultaneously.
Below code is just to explain the above scenario :
/######################/
while(1)
{
retval=snd_pcm_readi(pAlsaConfig->pcm_handle, buffer,
pAlsaConfig->alsaBufferSize);
snd_pcm_writei(pAlsaConfig->pcm_handle1, buffer,retval);
snd_pcm_writei(pAlsaConfig->pcm_handle2, buffer,retval);
}/######################/
In above case, renderer 2 lags behind the renderer 1 i.e there is delay between two audio devices when actually heard.
Please help me if some better implementation for join play. I have seen some thing as snd_pcm_link(). But i was not clear with its usage, while doing snd_pcm_writei ???
Thanks and regards,
Irfan
Quoted 7 lines
while(1)
{ retval=snd_pcm_readi(pAlsaConfig->pcm_handle, buffer, pAlsaConfig->alsaBufferSize); snd_pcm_writei(pAlsaConfig->pcm_handle1, buffer,retval); snd_pcm_writei(pAlsaConfig->pcm_handle2, buffer,retval); }
This code doesn't work in the general case where the different devices don't share a common audio clock and have different physical capture/playback rates. Compensating for clock drift requires the use of asynchronous sample-rate conversion.
Assuming you have a perfectly synchronous system, you could make use of snd_pcm_delay() to compensate for delays incurred in the driver/firmware/hardware. This is not well supported by all drivers though. -Pierre