Skip to contentSkip to conversation

AT91 NAND om AT91SAM9260EK

U-Boot-Users Ivan Kuten 1 participant 1 message Feb 8, 2007 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

Ivan Kuten

author
#1 lore raw
Quoted 8 lines

I tried to start the process of merging with mainstream U-boot by sending in a patch which split the at45.c located in board/at91rm9200dk into
* drivers/at45.c
* cpu/arm920t/at91rm9200/spi.c
but I have no feedback.

Quoted 8 lines

Peter Pearse which will be responsible for maintaining the ARM part is not up to speed yet, and noone else seems to be interested.

There has been a discussion about how dataflash should be supported but the things people do not like are not in this file, they are in the "board/dataflash.c" file so I have no clue why nothing is happening.

Hi Ulf,

It's a good decision to move board/at91rm9200dk/at45.c into drivers/at45.c cause our custom RM9200 board uses at45.c too.
We have dataflash only setup without NOR.

Also may be as suggestion to make AT91C_SPI_PCS3_DATAFLASH_CARD #ifdefed because some boards such as ours may not use CS3 at all.

Best regards, Ivan