AT91 NAND om AT91SAM9260EK
A message that is not in the archive (sent off-list or not yet received): [email protected]
Quoted 8 lines
I tried to start the process of merging with mainstream U-boot by sending in a patch which split the
at45.clocated in board/at91rm9200dk into
*drivers/at45.c
*cpu/arm920t/at91rm9200/spi.c
but I have no feedback.
Quoted 8 lines
Peter Pearse which will be responsible for maintaining the ARM part is not up to speed yet, and noone else seems to be interested.
There has been a discussion about how dataflash should be supported but the things people do not like are not in this file, they are in the "
board/dataflash.c" file so I have no clue why nothing is happening.
Hi Ulf,
It's a good decision to move board/at91rm9200dk/at45.c into drivers/at45.c cause our custom RM9200 board uses at45.c too.
We have dataflash only setup without NOR.
Also may be as suggestion to make AT91C_SPI_PCS3_DATAFLASH_CARD #ifdefed because some boards such as ours may not use CS3 at all.
Best regards, Ivan