ARM: at91: Allow running SPL with DTB append
Subsystems (2)
v2 cover ARM: at91: Allow running SPL with DTB append
Hello,
a few months ago I submitted a small series allowing to run SPL with DTB append. Indeed according to the linker BSS section was all the time separated for SPL but the symbol SPL_SEPARATE_BSS was only enabled on some boards.
In this v2 the changes are:
- add reviewed-by Stefan Roese <[email protected]>
- modify a new defconfig sama5d3_xplained_nandflash_defconfig
Thanks,
Gregory
Gregory CLEMENT (2):
ARM: at91: Enable SPL_SEPARATE_BSS by default
configs: atmel: cleanup CONFIG_SPL_SEPARATE_BSS
arch/arm/Kconfig | 1 + configs/gardena-smart-gateway-at91sam_defconfig | 1 - configs/sama5d27_som1_ek_mmc1_defconfig | 1 - configs/sama5d27_som1_ek_mmc_defconfig | 1 - configs/sama5d27_som1_ek_qspiflash_defconfig | 1 - configs/sama5d27_wlsom1_ek_mmc_defconfig | 1 - configs/sama5d27_wlsom1_ek_qspiflash_defconfig | 1 - configs/sama5d2_icp_mmc_defconfig | 1 - configs/sama5d2_xplained_emmc_defconfig | 1 - configs/sama5d2_xplained_mmc_defconfig | 1 - configs/sama5d2_xplained_qspiflash_defconfig | 1 - configs/sama5d3_xplained_mmc_defconfig | 1 - configs/sama5d3xek_mmc_defconfig | 1 - configs/sama5d4_xplained_mmc_defconfig | 1 - configs/sama5d4ek_mmc_defconfig | 1 - 15 files changed, 1 insertion(+), 14 deletions(-)
Signature · 1 line
2.26.2
PATCH v2 1/2 ARM: at91: Enable SPL_SEPARATE_BSS by default
According to the linker script for both armv7 and arm926ejs based SoC, BSS section was all the time separated for SPL but this symbol was only enabled on some boards. However, it is necessary to have it enabled for OF_SEPARATE configuration where DTB is appended to u-boot with DTB.
--- arch/arm/Kconfig | 1 + 1 file changed, 1 insertion(+)
arch/arm/Kconfig +1 -0
@@ -532,6 +532,7 @@ choice config ARCH_AT91 bool "Atmel AT91" select SPL_BOARD_INIT if SPL && !TARGET_SMARTWEB + select SPL_SEPARATE_BSS if SPL config TARGET_EDB93XX bool "Support edb93xx"
Signature · 1 line
2.26.2
PATCH v2 2/2 configs: atmel: cleanup CONFIG_SPL_SEPARATE_BSS
In reply to Gregory CLEMENTNow that CONFIG_SPL_SEPARATE_BSS is selected for all the AT91 based boards, cleanups the defconfigs by removing it.
--- configs/gardena-smart-gateway-at91sam_defconfig | 1 - configs/sama5d27_som1_ek_mmc1_defconfig | 1 - configs/sama5d27_som1_ek_mmc_defconfig | 1 - configs/sama5d27_som1_ek_qspiflash_defconfig | 1 - configs/sama5d27_wlsom1_ek_mmc_defconfig | 1 - configs/sama5d27_wlsom1_ek_qspiflash_defconfig | 1 - configs/sama5d2_icp_mmc_defconfig | 1 - configs/sama5d2_xplained_emmc_defconfig | 1 - configs/sama5d2_xplained_mmc_defconfig | 1 - configs/sama5d2_xplained_qspiflash_defconfig | 1 - configs/sama5d3_xplained_mmc_defconfig | 1 - configs/sama5d3xek_mmc_defconfig | 1 - configs/sama5d4_xplained_mmc_defconfig | 1 - configs/sama5d4ek_mmc_defconfig | 1 - 14 files changed, 14 deletions(-)
configs/gardena-smart-gateway-at91sam_defconfig +0 -1
@@ -26,7 +26,6 @@ CONFIG_BOOTARGS="console=ttyS0,115200 earlyprintk mtdparts=atmel_nand:256k(boots CONFIG_SYS_CONSOLE_IS_IN_ENV=y CONFIG_SYS_CONSOLE_INFO_QUIET=y CONFIG_SPL_SYS_MALLOC_SIMPLE=y -CONFIG_SPL_SEPARATE_BSS=y # CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR is not set CONFIG_SPL_NAND_SUPPORT=y CONFIG_HUSH_PARSER=y
configs/sama5d27_som1_ek_mmc1_defconfig +0 -1
@@ -29,7 +29,6 @@ CONFIG_USE_BOOTARGS=y CONFIG_BOOTARGS="console=ttyS0,115200 earlyprintk root=/dev/mmcblk1p2 rw rootwait" CONFIG_MISC_INIT_R=y # CONFIG_DISPLAY_BOARDINFO is not set -CONFIG_SPL_SEPARATE_BSS=y CONFIG_HUSH_PARSER=y CONFIG_CMD_BOOTZ=y # CONFIG_CMD_FLASH is not set
configs/sama5d27_som1_ek_mmc_defconfig +0 -1
@@ -30,7 +30,6 @@ CONFIG_USE_BOOTARGS=y CONFIG_BOOTARGS="console=ttyS0,115200 earlyprintk root=/dev/mmcblk0p2 rw rootwait" CONFIG_MISC_INIT_R=y # CONFIG_DISPLAY_BOARDINFO is not set -CONFIG_SPL_SEPARATE_BSS=y CONFIG_HUSH_PARSER=y CONFIG_CMD_BOOTZ=y # CONFIG_CMD_FLASH is not set
configs/sama5d27_som1_ek_qspiflash_defconfig +0 -1
@@ -30,7 +30,6 @@ CONFIG_USE_BOOTARGS=y CONFIG_BOOTARGS="console=ttyS0,115200 earlyprintk root=/dev/mmcblk0p2 rw rootwait" CONFIG_MISC_INIT_R=y # CONFIG_DISPLAY_BOARDINFO is not set -CONFIG_SPL_SEPARATE_BSS=y CONFIG_HUSH_PARSER=y CONFIG_CMD_BOOTZ=y # CONFIG_CMD_FLASH is not set
configs/sama5d27_wlsom1_ek_mmc_defconfig +0 -1
@@ -28,7 +28,6 @@ CONFIG_USE_BOOTARGS=y CONFIG_MISC_INIT_R=y # CONFIG_DISPLAY_BOARDINFO is not set CONFIG_DISPLAY_BOARDINFO_LATE=y -CONFIG_SPL_SEPARATE_BSS=y CONFIG_SPL_DISPLAY_PRINT=y # CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR is not set CONFIG_SPL_AT91_MCK_BYPASS=y
configs/sama5d27_wlsom1_ek_qspiflash_defconfig +0 -1
@@ -29,7 +29,6 @@ CONFIG_USE_BOOTARGS=y CONFIG_MISC_INIT_R=y # CONFIG_DISPLAY_BOARDINFO is not set CONFIG_DISPLAY_BOARDINFO_LATE=y -CONFIG_SPL_SEPARATE_BSS=y CONFIG_SPL_DISPLAY_PRINT=y # CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR is not set CONFIG_SPL_SPI_LOAD=y
configs/sama5d2_icp_mmc_defconfig +0 -1
@@ -26,7 +26,6 @@ CONFIG_SD_BOOT=y CONFIG_BOOTDELAY=3 CONFIG_USE_BOOTARGS=y # CONFIG_DISPLAY_BOARDINFO is not set -CONFIG_SPL_SEPARATE_BSS=y CONFIG_SPL_DISPLAY_PRINT=y # CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR is not set CONFIG_SPL_RAM_SUPPORT=y
configs/sama5d2_xplained_emmc_defconfig +0 -1
@@ -28,7 +28,6 @@ CONFIG_BOOTDELAY=3 CONFIG_USE_BOOTARGS=y CONFIG_BOOTARGS="console=ttyS0,115200 earlyprintk root=/dev/mmcblk0p2 rw rootwait" # CONFIG_DISPLAY_BOARDINFO is not set -CONFIG_SPL_SEPARATE_BSS=y CONFIG_HUSH_PARSER=y CONFIG_CMD_BOOTZ=y # CONFIG_CMD_FLASH is not set
configs/sama5d2_xplained_mmc_defconfig +0 -1
@@ -30,7 +30,6 @@ CONFIG_USE_BOOTARGS=y CONFIG_BOOTARGS="console=ttyS0,115200 earlyprintk root=/dev/mmcblk1p2 rw rootwait" CONFIG_MISC_INIT_R=y # CONFIG_DISPLAY_BOARDINFO is not set -CONFIG_SPL_SEPARATE_BSS=y CONFIG_HUSH_PARSER=y CONFIG_CMD_BOOTZ=y # CONFIG_CMD_FLASH is not set
configs/sama5d2_xplained_qspiflash_defconfig +0 -1
@@ -30,7 +30,6 @@ CONFIG_USE_BOOTARGS=y CONFIG_BOOTARGS="console=ttyS0,115200 earlyprintk root=/dev/mmcblk0p1 rw rootwait" CONFIG_MISC_INIT_R=y # CONFIG_DISPLAY_BOARDINFO is not set -CONFIG_SPL_SEPARATE_BSS=y CONFIG_HUSH_PARSER=y CONFIG_CMD_BOOTZ=y # CONFIG_CMD_FLASH is not set
configs/sama5d3_xplained_mmc_defconfig +0 -1
@@ -28,7 +28,6 @@ CONFIG_BOOTDELAY=3 CONFIG_USE_BOOTARGS=y CONFIG_BOOTARGS="console=ttyS0,115200 earlyprintk root=/dev/mmcblk0p2 rw rootwait" # CONFIG_DISPLAY_BOARDINFO is not set -CONFIG_SPL_SEPARATE_BSS=y CONFIG_HUSH_PARSER=y CONFIG_CMD_BOOTZ=y # CONFIG_CMD_FLASH is not set
configs/sama5d3xek_mmc_defconfig +0 -1
@@ -30,7 +30,6 @@ CONFIG_BOOTARGS="console=ttyS0,115200 earlyprintk root=/dev/mmcblk0p2 rw rootwai # CONFIG_CONSOLE_MUX is not set CONFIG_SYS_CONSOLE_IS_IN_ENV=y # CONFIG_DISPLAY_BOARDINFO is not set -CONFIG_SPL_SEPARATE_BSS=y CONFIG_HUSH_PARSER=y CONFIG_CMD_BOOTZ=y # CONFIG_CMD_IMI is not set
configs/sama5d4_xplained_mmc_defconfig +0 -1
@@ -29,7 +29,6 @@ CONFIG_USE_BOOTARGS=y CONFIG_BOOTARGS="console=ttyS0,115200 earlyprintk root=/dev/mmcblk0p2 rw rootwait" CONFIG_MISC_INIT_R=y # CONFIG_DISPLAY_BOARDINFO is not set -CONFIG_SPL_SEPARATE_BSS=y CONFIG_HUSH_PARSER=y CONFIG_CMD_BOOTZ=y # CONFIG_CMD_FLASH is not set
configs/sama5d4ek_mmc_defconfig +0 -1
@@ -30,7 +30,6 @@ CONFIG_BOOTARGS="console=ttyS0,115200 earlyprintk root=/dev/mmcblk0p2 rw rootwai # CONFIG_CONSOLE_MUX is not set CONFIG_SYS_CONSOLE_IS_IN_ENV=y # CONFIG_DISPLAY_BOARDINFO is not set -CONFIG_SPL_SEPARATE_BSS=y CONFIG_HUSH_PARSER=y CONFIG_CMD_BOOTZ=y # CONFIG_CMD_IMI is not set
Signature · 1 line
2.26.2
v2 cover ARM: at91: Allow running SPL with DTB append
In reply to Gregory CLEMENTQuoted 37 lines · Gregory CLEMENT
Hello,
a few months ago I submitted a small series allowing to run SPL with DTB append. Indeed according to the linker BSS section was all the time separated for SPL but the symbol
SPL_SEPARATE_BSSwas only enabled on some boards.In this v2 the changes are:
- add reviewed-by Stefan Roese <[email protected]>
- modify a new defconfigsama5d3_xplained_nandflash_defconfigThanks,
Gregory
Gregory CLEMENT (2):
ARM: at91: EnableSPL_SEPARATE_BSSby default
configs: atmel: cleanupCONFIG_SPL_SEPARATE_BSSarch/arm/Kconfig | 1 + configs/gardena-smart-gateway-at91sam_defconfig | 1 - configs/sama5d27_som1_ek_mmc1_defconfig | 1 - configs/sama5d27_som1_ek_mmc_defconfig | 1 - configs/sama5d27_som1_ek_qspiflash_defconfig | 1 - configs/sama5d27_wlsom1_ek_mmc_defconfig | 1 - configs/sama5d27_wlsom1_ek_qspiflash_defconfig | 1 - configs/sama5d2_icp_mmc_defconfig | 1 - configs/sama5d2_xplained_emmc_defconfig | 1 - configs/sama5d2_xplained_mmc_defconfig | 1 - configs/sama5d2_xplained_qspiflash_defconfig | 1 - configs/sama5d3_xplained_mmc_defconfig | 1 - configs/sama5d3xek_mmc_defconfig | 1 - configs/sama5d4_xplained_mmc_defconfig | 1 - configs/sama5d4ek_mmc_defconfig | 1 - 15 files changed, 1 insertion(+), 14 deletions(-)
Quoted 3 lines
--
2.26.2
Applied to u-boot-atmel/master,
Thanks!