Skip to contentSkip to conversation

obexd: client: Fix connect RX MTU

PATCH Applied Frédéric Danis 3 participants 3 messages Aug 26, 2025 Bluetooth drivers

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 obexd: client: Fix connect RX MTU

OBEX download from iPhone is currently slow due to small packet size used to transfer data which doesn't follow the MTU negotiated during L2CAP connection, i.e. 672 bytes instead of 32767:

< ACL Data TX: Handle 11 flags 0x00 dlen 12

      L2CAP: Connection Request (0x02) ident 18 len 4
        PSM: 4103 (0x1007)
        Source CID: 72
Quoted 1 line

ACL Data RX: Handle 11 flags 0x02 dlen 16

      L2CAP: Connection Response (0x03) ident 18 len 8
        Destination CID: 14608
        Source CID: 72
        Result: Connection successful (0x0000)
        Status: No further information available (0x0000)
  < ACL Data TX: Handle 11 flags 0x00 dlen 27
      L2CAP: Configure Request (0x04) ident 20 len 19
        Destination CID: 14608
        Flags: 0x0000
        Option: Maximum Transmission Unit (0x01) [mandatory]
          MTU: 32767
        Option: Retransmission and Flow Control (0x04) [mandatory]
          Mode: Enhanced Retransmission (0x03)
          TX window size: 63
          Max transmit: 3
          Retransmission timeout: 2000
          Monitor timeout: 12000
          Maximum PDU size: 1009
Quoted 1 line

ACL Data RX: Handle 11 flags 0x02 dlen 26

      L2CAP: Configure Request (0x04) ident 72 len 18
        Destination CID: 72
        Flags: 0x0000
        Option: Retransmission and Flow Control (0x04) [mandatory]
          Mode: Enhanced Retransmission (0x03)
          TX window size: 32
          Max transmit: 255
          Retransmission timeout: 0
          Monitor timeout: 0
          Maximum PDU size: 65527
        Option: Frame Check Sequence (0x05) [mandatory]
          FCS: 16-bit FCS (0x01)
  < ACL Data TX: Handle 11 flags 0x00 dlen 29
      L2CAP: Configure Response (0x05) ident 72 len 21
        Source CID: 14608
        Flags: 0x0000
        Result: Success (0x0000)
        Option: Maximum Transmission Unit (0x01) [mandatory]
          MTU: 672
        Option: Retransmission and Flow Control (0x04) [mandatory]
          Mode: Enhanced Retransmission (0x03)
          TX window size: 32
          Max transmit: 255
          Retransmission timeout: 2000
          Monitor timeout: 12000
          Maximum PDU size: 1009
Quoted 1 line

ACL Data RX: Handle 11 flags 0x02 dlen 32

      L2CAP: Configure Response (0x05) ident 20 len 24
        Source CID: 72
        Flags: 0x0000
        Result: Success (0x0000)
        Option: Maximum Transmission Unit (0x01) [mandatory]
          MTU: 32767
        Option: Retransmission and Flow Control (0x04) [mandatory]
          Mode: Enhanced Retransmission (0x03)
          TX window size: 63
          Max transmit: 3
          Retransmission timeout: 2000
          Monitor timeout: 12000
          Maximum PDU size: 1009
        Option: Frame Check Sequence (0x05) [mandatory]
          FCS: 16-bit FCS (0x01)
  ...
  < ACL Data TX: Handle 11 flags 0x00 dlen 34
      Channel: 14608 len 30 ctrl 0x0000 [PSM 4103 mode Enhanced Retransmission (0x03)] {chan 8}
      I-frame: Unsegmented TxSeq 0 ReqSeq 0
        00 00 80 00 1a 10 00 02 a0 46 00 13 71 63 dd 54  .........F..qc.T
        4a 7e 11 e2 b4 7c 00 50 c2 49 00 48 b4 55        J~...|.P.I.H.U

...

Quoted 1 line

ACL Data RX: Handle 11 flags 0x02 dlen 680

Channel: 72 len 676 ctrl 0x0202 [PSM 4103 mode Enhanced Retransmission (0x03)] {chan 8}
I-frame: Unsegmented TxSeq 1 ReqSeq 2
< ACL Data TX: Handle 11 flags 0x00 dlen 13
Channel: 14608 len 9 ctrl 0x0204 [PSM 4103 mode Enhanced Retransmission (0x03)] {chan 8}
I-frame: Unsegmented TxSeq 2 ReqSeq 2

Quoted 1 line

ACL Data RX: Handle 11 flags 0x02 dlen 680

Channel: 72 len 676 ctrl 0x0304 [PSM 4103 mode Enhanced Retransmission (0x03)] {chan 8}
I-frame: Unsegmented TxSeq 2 ReqSeq 3

The OBEX CONNECT request uses the negotiated output MTU (672, 0x02a0) as the maximum OBEX packet length the client is able to receive instead of the negotiated input MTU (32767).

This commit swap rx_mtu and tx_mtu as g_obex_new() is defined as:
GObex *g_obex_new(GIOChannel *io, GObexTransportType transport_type,

     gssize rx_mtu, gssize tx_mtu);
---
 obexd/client/session.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)
obexd/client/session.c +1 -1
index fa9bd7d17..89c877f08 100644
@@ -373,7 +373,7 @@ static void transport_func(GIOChannel *io, GError *err, gpointer user_data)
 	else
 		type = G_OBEX_TRANSPORT_STREAM;
 
-	obex = g_obex_new(io, type, tx_mtu, rx_mtu);
+	obex = g_obex_new(io, type, rx_mtu, tx_mtu);
 	if (obex == NULL)
 		goto done;
 
Signature · 1 line
2.43.0
#1 lore raw

This is automated email and please do not reply to this email!

Dear submitter,

Thank you for submitting the patches to the linux bluetooth mailing list. This is a CI test results with your patch series:
PW Link:https://patchwork.kernel.org/project/bluetooth/list/?series=995586

---Test result---

Test Summary:

CheckPatch                    PENDING   0.36 seconds
GitLint                       PENDING   0.29 seconds
BuildEll                      PASS      20.06 seconds
BluezMake                     PASS      2614.40 seconds
MakeCheck                     PASS      19.93 seconds
MakeDistcheck                 PASS      182.12 seconds
CheckValgrind                 PASS      233.99 seconds
CheckSmatch                   PASS      304.90 seconds
bluezmakeextell               PASS      126.83 seconds
IncrementalBuild              PENDING   0.30 seconds
ScanBuild                     PASS      898.83 seconds

Details
##############################
Test: CheckPatch - PENDING
Desc: Run checkpatch.pl script
Output:

##############################
Test: GitLint - PENDING
Desc: Run gitlint
Output:

##############################
Test: IncrementalBuild - PENDING
Desc: Incremental build with the patches in the series Output:

---
Regards,
Linux Bluetooth

#2 lore raw
In reply to Frédéric Danis
This patch was applied to bluetooth/bluez.git (master) by Luiz Augusto von Dentz <[email protected]>:

Hello:

This patch was applied to bluetooth/bluez.git (master) by Luiz Augusto von Dentz <[email protected]>:

Quoted 83 lines · On Tue, 26 Aug 2025 11:05:43 +0200 you wrote:

OBEX download from iPhone is currently slow due to small packet size used to transfer data which doesn't follow the MTU negotiated during L2CAP connection, i.e. 672 bytes instead of 32767:

< ACL Data TX: Handle 11 flags 0x00 dlen 12

      L2CAP: Connection Request (0x02) ident 18 len 4
        PSM: 4103 (0x1007)
        Source CID: 72
Quoted 1 line

ACL Data RX: Handle 11 flags 0x02 dlen 16

      L2CAP: Connection Response (0x03) ident 18 len 8
        Destination CID: 14608
        Source CID: 72
        Result: Connection successful (0x0000)
        Status: No further information available (0x0000)
  < ACL Data TX: Handle 11 flags 0x00 dlen 27
      L2CAP: Configure Request (0x04) ident 20 len 19
        Destination CID: 14608
        Flags: 0x0000
        Option: Maximum Transmission Unit (0x01) [mandatory]
          MTU: 32767
        Option: Retransmission and Flow Control (0x04) [mandatory]
          Mode: Enhanced Retransmission (0x03)
          TX window size: 63
          Max transmit: 3
          Retransmission timeout: 2000
          Monitor timeout: 12000
          Maximum PDU size: 1009
Quoted 1 line

ACL Data RX: Handle 11 flags 0x02 dlen 26

      L2CAP: Configure Request (0x04) ident 72 len 18
        Destination CID: 72
        Flags: 0x0000
        Option: Retransmission and Flow Control (0x04) [mandatory]
          Mode: Enhanced Retransmission (0x03)
          TX window size: 32
          Max transmit: 255
          Retransmission timeout: 0
          Monitor timeout: 0
          Maximum PDU size: 65527
        Option: Frame Check Sequence (0x05) [mandatory]
          FCS: 16-bit FCS (0x01)
  < ACL Data TX: Handle 11 flags 0x00 dlen 29
      L2CAP: Configure Response (0x05) ident 72 len 21
        Source CID: 14608
        Flags: 0x0000
        Result: Success (0x0000)
        Option: Maximum Transmission Unit (0x01) [mandatory]
          MTU: 672
        Option: Retransmission and Flow Control (0x04) [mandatory]
          Mode: Enhanced Retransmission (0x03)
          TX window size: 32
          Max transmit: 255
          Retransmission timeout: 2000
          Monitor timeout: 12000
          Maximum PDU size: 1009
Quoted 1 line

ACL Data RX: Handle 11 flags 0x02 dlen 32

      L2CAP: Configure Response (0x05) ident 20 len 24
        Source CID: 72
        Flags: 0x0000
        Result: Success (0x0000)
        Option: Maximum Transmission Unit (0x01) [mandatory]
          MTU: 32767
        Option: Retransmission and Flow Control (0x04) [mandatory]
          Mode: Enhanced Retransmission (0x03)
          TX window size: 63
          Max transmit: 3
          Retransmission timeout: 2000
          Monitor timeout: 12000
          Maximum PDU size: 1009
        Option: Frame Check Sequence (0x05) [mandatory]
          FCS: 16-bit FCS (0x01)
  ...
  < ACL Data TX: Handle 11 flags 0x00 dlen 34
      Channel: 14608 len 30 ctrl 0x0000 [PSM 4103 mode Enhanced Retransmission (0x03)] {chan 8}
      I-frame: Unsegmented TxSeq 0 ReqSeq 0
        00 00 80 00 1a 10 00 02 a0 46 00 13 71 63 dd 54  .........F..qc.T
        4a 7e 11 e2 b4 7c 00 50 c2 49 00 48 b4 55        J~...|.P.I.H.U

...

Quoted 1 line

ACL Data RX: Handle 11 flags 0x02 dlen 680

Channel: 72 len 676 ctrl 0x0202 [PSM 4103 mode Enhanced Retransmission (0x03)] {chan 8}
I-frame: Unsegmented TxSeq 1 ReqSeq 2
< ACL Data TX: Handle 11 flags 0x00 dlen 13
Channel: 14608 len 9 ctrl 0x0204 [PSM 4103 mode Enhanced Retransmission (0x03)] {chan 8}
I-frame: Unsegmented TxSeq 2 ReqSeq 2

Quoted 5 lines
Quoted 1 line

ACL Data RX: Handle 11 flags 0x02 dlen 680

Channel: 72 len 676 ctrl 0x0304 [PSM 4103 mode Enhanced Retransmission (0x03)] {chan 8}
I-frame: Unsegmented TxSeq 2 ReqSeq 3

[...]

Here is the summary with links:
- [BlueZ] obexd: client: Fix connect RX MTU

    https://git.kernel.org/pub/scm/bluetooth/bluez.git/?id=99abc8a9e1e1

You are awesome, thank you!

Signature · 2 lines
Deet-doot-dot, I am a bot.
https://korg.docs.kernel.org/patchwork/pwbot.html