Skip to contentSkip to conversation

Information about Uboot porting

U-Boot-Users eagle keeper 2 participants 2 messages Dec 19, 2005

lore
Share & tools
lore
#0 lore raw

Hi all,
I'd like to ask for a guide-line.
I have to port u-boot to a ppc board based on mpc860p, but this board has not bcsr.
I have seen in the code that Uboot enables ethernet rs232 and sdram using bcsr.
How can I enable RS232, ethernet and sdram without bcsr?
Is there a somehow standard way to procede?

Thanks in advance
Emanuele

PS: Of course I am not asking for the implementation, but only for a procedure.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.denx.de/pipermail/u-boot/attachments/20051219/2310a4fe/attachment.htm

#1 lore raw
Quoted 3 lines · In message <[email protected]> you wrote:

I have to port u-boot to a ppc board based on mpc860p, but this board has not bcsr.

You are lucky, then.

Quoted 2 lines

I have seen in the code that Uboot enables ethernet rs232 and sdram using bcsr.

Umm.... only very few boards use a BCSR.

Quoted 2 lines

How can I enable RS232, ethernet and sdram without bcsr? Is there a somehow standard way to procede?

Yes, there is. Check any 8xx board excluding the Motorola/Freescale boards... The standard is NOT having a BCSR.

Best regards,

Wolfgang Denk

Signature · 6 lines
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
It's certainly  convenient  the  way  the  crime  (or  condition)  of
stupidity   carries   with   it  its  own  punishment,  automatically
admisistered without remorse, pity, or prejudice. :-)
         -- Tom Christiansen in <[email protected]>