Information about Uboot porting
Hi all,
I'd like to ask for a guide-line.
I have to port u-boot to a ppc board based on mpc860p, but this board has not bcsr.
I have seen in the code that Uboot enables ethernet rs232 and sdram using bcsr.
How can I enable RS232, ethernet and sdram without bcsr?
Is there a somehow standard way to procede?
Thanks in advance
Emanuele
PS: Of course I am not asking for the implementation, but only for a procedure.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.denx.de/pipermail/u-boot/attachments/20051219/2310a4fe/attachment.htm
Quoted 3 lines · In message <[email protected]> you wrote:
I have to port u-boot to a ppc board based on mpc860p, but this board has not bcsr.
You are lucky, then.
Quoted 2 lines
I have seen in the code that Uboot enables ethernet rs232 and sdram using bcsr.
Umm.... only very few boards use a BCSR.
Quoted 2 lines
How can I enable RS232, ethernet and sdram without bcsr? Is there a somehow standard way to procede?
Yes, there is. Check any 8xx board excluding the Motorola/Freescale boards... The standard is NOT having a BCSR.
Best regards,
Wolfgang Denk
Signature · 6 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
It's certainly convenient the way the crime (or condition) of
stupidity carries with it its own punishment, automatically
admisistered without remorse, pity, or prejudice. :-)
-- Tom Christiansen in <[email protected]>