Skip to contentSkip to conversation

lspci != scanpci !?

DISCUSSION Enrico Bartky 1 participant 1 message Jan 14, 2005

lore
Share & tools
lore
#0 lore raw

In the kernel config I have aktivate the direct pci-access.

Matthew Dharm <[email protected]> schrieb am 14.01.05 23:37:23:

Quoted 27 lines · Enrico Bartky

Hello,

I have a Gigabyte GA-5AA Board with ALi Aladdin IV Chipset ( 1533, 1541 ). I tried to get the smbus to work, but Gigabyte have disabled it and I can't activate it in the BIOS. I use kernel 2.6.10 and looked at the m7101-hotplug for kernel 2.4-module from lm_sensors. I added the following to drivers/pci/quirks.c:

....
/* ALi 1533 fixup to enable the M7101 SMBus Controller
* ported from prog/hotplug of the lm_sensors
* package
*/
static void __devinit quirk_ali1533_smbus(struct pci_dev *dev) {
u8 val = 0;

pci_read_config_byte ( dev, 0x5F, &val );
if ( val & 0x4 )
{
pci_write_config_byte ( dev, 0x5F, val & 0xFB );
}
}
DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_AL, PCI_DEVICE_ID_AL_M1533, quirk_ali1533_smbus );
....

Quoted 3 lines

Now the scanpci command shows the M7101 BUT lspci and /proc/pci, /proc/bus/pci, /sys/bus/pci NOT. What can I do? Is there anything like a "update_pci" command?

I think there is a kernel command-line parameter you can use to tell the kernel to ignore the BIOS-supplied PCI map and generate it's own via scanning (ala what scanpci does).

Matt

Signature · 12 lines
Matthew Dharm                              Home: [email protected] 
Maintainer, Linux USB Mass Storage Driver

Department of Justice agent.  I have come to purify the flock.
					-- DOJ agent
User Friendly, 5/22/1998



__________________________________________________________
Mit WEB.DE FreePhone mit hoechster Qualitaet ab 0 Ct./Min.
weltweit telefonieren! http://freephone.web.de/?mc=021201