ARM: mvebu: Add DT entry for ReadyNAS Duo v2 to use gpio-poweroff driver
PATCH v2 1/1 ARM: mvebu: Add DT entry for ReadyNAS Duo v2 to use gpio-poweroff driver
Without that fix, at the end of the shutdown process, the board is still powered (led glowing, fan running, ...).
Signed-off-by Arnaud Ebalard <[email protected]>
---
Changes since v1:
- use macro instead of value for GPIO voltage level
arch/arm/boot/dts/kirkwood-netgear_readynas_duo_v2.dts | 12 ++++++++++++ 1 file changed, 12 insertions(+)
arch/arm/boot/dts/kirkwood-netgear_readynas_duo_v2.dts +12 -0
@@ -1,5 +1,6 @@ /dts-v1/; +#include <dt-bindings/gpio/gpio.h> #include "kirkwood.dtsi" #include "kirkwood-6282.dtsi"
@@ -60,6 +61,10 @@ marvell,pins = "mpp29"; marvell,function = "gpio"; }; + pmx_poweroff: pmx-poweroff { + marvell,pins = "mpp30"; + marvell,function = "gpio"; + }; }; clocks {
@@ -158,6 +163,13 @@ }; }; + gpio-poweroff { + compatible = "gpio-poweroff"; + pinctrl-0 = <&pmx_poweroff>; + pinctrl-names = "default"; + gpios = <&gpio0 30 GPIO_ACTIVE_LOW>; + }; + regulators { compatible = "simple-bus"; #address-cells = <1>;
Signature · 1 line
1.8.4.4
Jason Cooper
AppliedPATCH v2 1/1 ARM: mvebu: Add DT entry for ReadyNAS Duo v2 to use gpio-poweroff driver
Quoted 4 lines · Arnaud Ebalard
Without that fix, at the end of the shutdown process, the board is still powered (led glowing, fan running, ...).
Quoted 8 lines
Signed-off-by Arnaud Ebalard <[email protected]>---
Changes since v1:
- use macro instead of value for GPIO voltage levelarch/arm/boot/dts/kirkwood-netgear_readynas_duo_v2.dts | 12 ++++++++++++ 1 file changed, 12 insertions(+)
Applied to mvebu/dt
thx,
Jason.