Skip to contentSkip to conversation

ARM: mvebu: Add DT entry for ReadyNAS Duo v2 to use gpio-poweroff driver

PATCH New Arnaud Ebalard 2 participants 2 messages Nov 22, 2013 – Nov 24, 2013 Device tree bindings

lore
Share & tools
lore
#0 lore raw

PATCH v2 1/1 ARM: mvebu: Add DT entry for ReadyNAS Duo v2 to use gpio-poweroff driver

Without that fix, at the end of the shutdown process, the board is still powered (led glowing, fan running, ...).

---

Changes since v1:
- use macro instead of value for GPIO voltage level

 arch/arm/boot/dts/kirkwood-netgear_readynas_duo_v2.dts | 12 ++++++++++++
 1 file changed, 12 insertions(+)
arch/arm/boot/dts/kirkwood-netgear_readynas_duo_v2.dts +12 -0
index e6a102c..551bfed 100644
@@ -1,5 +1,6 @@
 /dts-v1/;
 
+#include <dt-bindings/gpio/gpio.h>
 #include "kirkwood.dtsi"
 #include "kirkwood-6282.dtsi"
 
@@ -60,6 +61,10 @@
 				marvell,pins = "mpp29";
 				marvell,function = "gpio";
 			};
+			pmx_poweroff: pmx-poweroff {
+				marvell,pins = "mpp30";
+				marvell,function = "gpio";
+			};
 		};
 
 		clocks {
@@ -158,6 +163,13 @@
 		};
 	};
 
+	gpio-poweroff {
+		compatible = "gpio-poweroff";
+		pinctrl-0 = <&pmx_poweroff>;
+		pinctrl-names = "default";
+		gpios = <&gpio0 30 GPIO_ACTIVE_LOW>;
+	};
+
         regulators {
                 compatible = "simple-bus";
                 #address-cells = <1>;
Signature · 1 line
1.8.4.4
Applied
#1 lore raw

PATCH v2 1/1 ARM: mvebu: Add DT entry for ReadyNAS Duo v2 to use gpio-poweroff driver

Quoted 4 lines · Arnaud Ebalard

Without that fix, at the end of the shutdown process, the board is still powered (led glowing, fan running, ...).

Quoted 8 lines

---

Changes since v1:
- use macro instead of value for GPIO voltage level

 arch/arm/boot/dts/kirkwood-netgear_readynas_duo_v2.dts | 12 ++++++++++++
 1 file changed, 12 insertions(+)

Applied to mvebu/dt

thx,

Jason.