Skip to contentSkip to conversation

arm64: dts: marvell: mcbin: enable the mdio node

PATCH New Antoine Tenart 2 participants 2 messages Jun 19, 2017 – Jun 20, 2017

Subsystems (3)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 arm64: dts: marvell: mcbin: enable the mdio node

Since the mdio nodes are disabled by default now, we should explicitly enable these nodes at the board level when they are used. Enable the cpm_mdio node for the 8040-mcbin.

---

Hi Gregory,

The series disabling the mdio nodes at the SoC level forgot to enable the cpm_mdio node for the 8040-mcbin. This is based on mvebu/dt64.

Thanks,
Antoine

 arch/arm64/boot/dts/marvell/armada-8040-mcbin.dts | 2 ++
 1 file changed, 2 insertions(+)
arch/arm64/boot/dts/marvell/armada-8040-mcbin.dts +2 -0
index fe56efcfcefe..4968e731de61 100644
@@ -116,6 +116,8 @@
 };
 
 &cpm_mdio {
+	status = "okay";
+
 	ge_phy: ethernet-phy at 0 {
 		reg = <0>;
 	};
Signature · 1 line
2.9.4
#1 lore raw

PATCH 1/1 arm64: dts: marvell: mcbin: enable the mdio node

Hi Antoine,

Quoted 5 lines · Antoine Tenart

Since the mdio nodes are disabled by default now, we should explicitly enable these nodes at the board level when they are used. Enable the cpm_mdio node for the 8040-mcbin.

Applied on mvebu/dt64

Thanks,

Gregory

Quoted 29 lines

---

Hi Gregory,

The series disabling the mdio nodes at the SoC level forgot to enable the cpm_mdio node for the 8040-mcbin. This is based on mvebu/dt64.

Thanks,
Antoine

 arch/arm64/boot/dts/marvell/armada-8040-mcbin.dts | 2 ++
 1 file changed, 2 insertions(+)
arch/arm64/boot/dts/marvell/armada-8040-mcbin.dts +2 -0
index fe56efcfcefe..4968e731de61 100644
@@ -116,6 +116,8 @@
 };
 
 &cpm_mdio {
+	status = "okay";
+
 	ge_phy: ethernet-phy at 0 {
 		reg = <0>;
 	};
Signature · 1 line
2.9.4
Signature · 4 lines
Gregory Clement, Free Electrons
Kernel, drivers, real-time and embedded Linux
development, consulting, training and support.
http://free-electrons.com