ath10k support to monitor mode
Thank you in advance for the work that you do. Request your assistance for a clearer understanding on the capabilities of the ath10k.
* Does the ath10k currently support monitor mode?
* If not, is it s firmware limitation that cannot be enabled until the firmware includes it or is it a driver limitation in which monitor mode just has not been prioritized to be worked into the driver yet?
* Is it a hardware limitation based on my specific card, the QCA6174?
Reviewing the linux-wireless website, it is noted that the ath10k supports monitor mode:
https://wireless.wiki.kernel.org/en/users/drivers/ath10k/monitor
Meaning at least it has been supported in the past. However my current configuration:
~~~~~~~~~~~~
Network: Card-1: Qualcomm Atheros QCA6174 802.11ac Wireless Network Adapter
driver: ath10k_pci
ath10k_pci 0000:06:00.0: qca6174 hw3.2 target 0x05030000 chip_id 0x00340aff sub 1a56:1535 ath10k_pci 0000:06:00.0: kconfig debug 0 debugfs 0 tracing 0 dfs 0 testmode 0ath10k_pci 0000:06:00.0: firmware ver WLAN.RM.4.4-00022-QCARMSWPZ-2 api 5 features wowlan,ignore-otp crc32 4d458559 ath10k_pci 0000:06:00.0: firmware: direct-loading firmware ath10k/QCA6174/hw3.0/board-2.bin ath10k_pci 0000:06:00.0: board_file api 2 bmi_id N/A crc32 07ee144eath10k_pci 0000:06:00.0: htt-ver 3.32 wmi-op 4 htt-op 3 cal otp max-sta 32 raw 0 hwcrypto 1
~~~~~~~~~~~~~~
does not seem to support monitor mode as I get no data when attempting to place it in monitor mode.
I have seen similar requests/problems with others having the same card on other websites wanting to place into monitor mode as well.
Appreciate any assistance to help me understand the problem. Thank you in advance.
V/R
Rett
_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k