Skip to contentSkip to conversation

Serial download, hangs in kermit receive problem

U-Boot 王培养 2 participants 2 messages Oct 23, 2009

lore
Share & tools
lore

王培养

author
#0 lore raw

hi,all
?i porting u-boot-1.3.4 to s3c44box.when i porting uclinux to board, then there is the problem as follows:

END-class command failed.
Packets sent: 1301
Retransmissions: 11
Timeouts: 0
Damaged packets: 0
Fatal Kermit Protocol Error: Too many retries
HINTS... If the preceding error message does not explain the failure:
Try changing the remote Kermit's FLOW-CONTROL setting.
Try it again with SET STREAMING OFF.
Try it again with SET PARITY SPACE.
As a last resort, give a ROBUST command and try again. Also:
Be sure the source file has read permission.
Be sure the target directory has write permission.
(Use SET HINTS OFF to suppress hints.)
*************************
Pls help me.
regards,juan

      ___________________________________________________________ 

?????????????????
http://card.mail.cn.yahoo.com/

#1 lore raw

Dear =?utf-8?B?546L5Z+55YW7ICA=?=,

Quoted 11 lines · In message <[email protected]> you wrote:

i porting u-boot-1.3.4 to s3c44box.when i porting uclinux to board, then there is the problem as follows:

END-class command failed.
Packets sent: 1301
Retransmissions: 11
Timeouts: 0
Damaged packets: 0
Fatal Kermit Protocol Error: Too many retries
HINTS... If the preceding error message does not explain the failure:

^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^

Quoted 1 line

Try changing the remote Kermit's FLOW-CONTROL setting.

^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^

Quoted 1 line

Try it again with SET STREAMING OFF.

^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^

Quoted 1 line

Try it again with SET PARITY SPACE.

^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^

Quoted 1 line

As a last resort, give a ROBUST command and try again.

^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^]

Quoted 1 line

Pls help me.

Well, did you read what kermit printed out for you? And did you follow the hints?

Or did you read the manual, say section "4.3. Configuring the "kermit" command" at http://www.denx.de/wiki/view/DULG/SystemSetup#Section_4.3.
?

Best regards,

Wolfgang Denk

Signature · 8 lines
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
"No proper program contains  an  indication  which  as  an  operator-
applied  occurrence  identifies an operator-defining occurrence which
as an indication-applied occurrence identifies an indication-defining
occurrence different from the one identified by the given  indication
as an indication-applied occurrence."               - ALGOL 68 Report