Serial download, hangs in kermit receive problem
hi,all
?i porting u-boot-1.3.4 to s3c44box.when i porting uclinux to board, then there is the problem as follows:
END-class command failed.
Packets sent: 1301
Retransmissions: 11
Timeouts: 0
Damaged packets: 0
Fatal Kermit Protocol Error: Too many retries
HINTS... If the preceding error message does not explain the failure:
Try changing the remote Kermit's FLOW-CONTROL setting.
Try it again with SET STREAMING OFF.
Try it again with SET PARITY SPACE.
As a last resort, give a ROBUST command and try again. Also:
Be sure the source file has read permission.
Be sure the target directory has write permission.
(Use SET HINTS OFF to suppress hints.)
*************************
Pls help me.
regards,juan
___________________________________________________________
?????????????????
http://card.mail.cn.yahoo.com/
Dear =?utf-8?B?546L5Z+55YW7ICA=?=,
Quoted 11 lines · In message <[email protected]> you wrote:
i porting u-boot-1.3.4 to s3c44box.when i porting uclinux to board, then there is the problem as follows:
END-class command failed.
Packets sent: 1301
Retransmissions: 11
Timeouts: 0
Damaged packets: 0
Fatal Kermit Protocol Error: Too many retries
HINTS... If the preceding error message does not explain the failure:
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Quoted 1 line
Try changing the remote Kermit's FLOW-CONTROL setting.
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Quoted 1 line
Try it again with SET STREAMING OFF.
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Quoted 1 line
Try it again with SET PARITY SPACE.
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Quoted 1 line
As a last resort, give a ROBUST command and try again.
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^]
Quoted 1 line
Pls help me.
Well, did you read what kermit printed out for you? And did you follow the hints?
Or did you read the manual, say section "4.3. Configuring the "kermit" command" at http://www.denx.de/wiki/view/DULG/SystemSetup#Section_4.3.
?
Best regards,
Wolfgang Denk
Signature · 8 lines
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de "No proper program contains an indication which as an operator- applied occurrence identifies an operator-defining occurrence which as an indication-applied occurrence identifies an indication-defining occurrence different from the one identified by the given indication as an indication-applied occurrence." - ALGOL 68 Report