HDSP -- linux CardBus issue : further information
Hi Paul,
Here are some new elements that may help you :
- You said that under windows the bios settings were used to configure the card, thus asked Ico and I to boot using pci=biosirq, which I did, to find that the card was given the same IRQ as before (10) (I was supposed to have an IO problem, not an IRQ one) . Then I checked under windows, and the card is given 9 as its IRQ, so there may be a problem using the bios settings on my machine under linux.
- There is something weird in the pci buses hierarchy on my machine. lspci -M gives:
00: Primary host bus
1e.0 Bridge to 02-02
01.0 Bridge to 01-01
01: Entered via 00:01.0
02: Entered via 00:1e.0
04.1 Bridge to 07-0a <crossing bug>
04.0 Bridge to 03-06 <crossing bug>03: Secondary host bus (?)
Thomas
_______________________________________________________________
Don't miss the 2002 Sprint PCS Application Developer's Conference August 25-28 in Las Vegas -- http://devcon.sprintpcs.com/adp/index.cfm
Quoted 9 lines · Thomas Charbonnel
Hi Paul,
Here are some new elements that may help you :
- You said that under windows the bios settings were used to configure the card, thus asked Ico and I to boot using pci=biosirq, which I did, to find that the card was given the same IRQ as before (10) (I was supposed to have an IO problem, not an IRQ one) . Then I checked under windows, and the card is given 9 as its IRQ, so there may be a problem using the bios settings on my machine under linux.
You might be able to specify IRQ 9 with "cb_pci_irq=9". Of course this depends on support of the IRQ router. There's a ton of useful information over at http://www.tldp.org/HOWTO/PCMCIA-HOWTO-5.html that is worth checking out.
784 - Michael C. Piantedosi - [email protected]
_______________________________________________________________
Don't miss the 2002 Sprint PCS Application Developer's Conference August 25-28 in Las Vegas -- http://devcon.sprintpcs.com/adp/index.cfm