Skip to contentSkip to conversation

SCSI????

DISCUSSION Miguel Maria Godinho de Matos 2 participants 2 messages Dec 8, 2001

lore
Share & tools
lore
#0 lore raw

I have recently compiled the kernel 2.4.16 in a P2 running red hat 7.2.

I have a hp82xxxx so i made sure i selected the SCSI support, as well as SCSI cdrom support and tape support ( don't know why though ) and disk support all that stuff, but i compiled them as an integrated part of the kernel and not as modules!!!!

I Also selected usb mass storage support and stuff but that doesn't matter for now!!

Well the problem is:

whenever linux boots it trys to load the Scsi modules for the new kernel but it [ fails ], i figure this is because my previous had scsi as module and now it isn't a module but a integrated part of the kernel, so i turned off the scsi from the service manager. ( don't know if i am right though ).

second, how do i make sure scsi support is actually running???

third, if scsi is running and if i have the usb mass storage built into the kernel, why doesn't my cd-rw appear listed as a scsi connected device as it should??

regards, Astinus.

#1 lore raw
Quoted 6 lines

I have recently compiled the kernel 2.4.16 in a P2 running red hat 7.2.

whenever linux boots it trys to load the Scsi modules for the new kernel but it [ fails ], i figure this is because my previous had scsi as module and now it isn't a module but a integrated part of the kernel, so i turned off the scsi from the service manager. ( don't know if i am right though ).

Did you accidentally copy the initrd= line from the old kernel to the new in your lilo or grub setup ?

Its a harmless warning anyway.

Quoted 1 line

second, how do i make sure scsi support is actually running???

cat /proc/scsi/scsi

Quoted 3 lines

third, if scsi is running and if i have the usb mass storage built into the kernel, why doesn't my cd-rw appear listed as a scsi connected device as it should??

That I don't know. Does it show up on /proc/bus/usb ?