SCSI????
I have recently compiled the kernel 2.4.16 in a P2 running red hat 7.2.
I have a hp82xxxx so i made sure i selected the SCSI support, as well as SCSI cdrom support and tape support ( don't know why though ) and disk support all that stuff, but i compiled them as an integrated part of the kernel and not as modules!!!!
I Also selected usb mass storage support and stuff but that doesn't matter for now!!
Well the problem is:
whenever linux boots it trys to load the Scsi modules for the new kernel but it [ fails ], i figure this is because my previous had scsi as module and now it isn't a module but a integrated part of the kernel, so i turned off the scsi from the service manager. ( don't know if i am right though ).
second, how do i make sure scsi support is actually running???
third, if scsi is running and if i have the usb mass storage built into the kernel, why doesn't my cd-rw appear listed as a scsi connected device as it should??
regards, Astinus.
Quoted 6 lines
I have recently compiled the kernel 2.4.16 in a P2 running red hat 7.2.
whenever linux boots it trys to load the Scsi modules for the new kernel but it [ fails ], i figure this is because my previous had scsi as module and now it isn't a module but a integrated part of the kernel, so i turned off the scsi from the service manager. ( don't know if i am right though ).
Did you accidentally copy the initrd= line from the old kernel to the new in your lilo or grub setup ?
Its a harmless warning anyway.
Quoted 1 line
second, how do i make sure scsi support is actually running???
cat /proc/scsi/scsi
Quoted 3 lines
third, if scsi is running and if i have the usb mass storage built into the kernel, why doesn't my cd-rw appear listed as a scsi connected device as it should??
That I don't know. Does it show up on /proc/bus/usb ?