Where's the list of needed hardware for donating?
Does a list exist describing the hardware needed or wished for to extend coverage for kernel development? I saw such a list at openbsd and thought it was a good idea.
Richard
Hi!
Quoted 3 lines
Does a list exist describing the hardware needed or wished for to extend coverage for kernel development? I saw such a list at openbsd and thought it was a good idea.
Heh, second zaurus for testing would certainly help ;-).
Pavel
Signature · 1 line
teflon -- maybe it is a trademark, but it should not be.
A message that is not in the archive (sent off-list or not yet received): [email protected]
A message that is not in the archive (sent off-list or not yet received): [email protected]
On 7/30/05, Pavel Machek <[email protected]> wrote:
-snip-snip-
Quoted 5 lines
Quoted 3 lines
The hardware I have may outdated/esoteric. I take it that there is
no such list then?
Maybe it's better not to support esoteric hardware.Post a list somewhere...
Ok, here's the list:
Adaptec AHA-1510A
(ISA, centronix-style external connector with terminator, one internal ribbon cable,
I probably have some centronix-style external cables around too, this card doesn't have it's own boot ROM)
Gravis UltraSound a.k.a. GUS
(ISA, fully loaded with memory, 1megabyte (I think))
Pertec MyTape 800
(I think this is a QIC tape drive that connects via the floppy interface)
TEAC 1.44 3.5 inch Floppy FDR
(FD-235HF)
Rocket Port 8-port serial board
(ISA, 8 - RJ11 jacks, made by Comtrol, brand-new in-box)
Quoted 10 lines · Richard Hubbell
Ok, here's the list:
Adaptec AHA-1510A
(ISA, centronix-style external connector with terminator, one internal ribbon cable,
I probably have some centronix-style external cables around too, this card doesn't have it's own boot ROM)Gravis UltraSound a.k.a. GUS
(ISA, fully loaded with memory, 1megabyte (I think))
Hasn't that been fully supported for years in ALSA? I remember the guy that started ALSA had written an amazing driver for the GUS before starting ALSA.
Quoted 2 lines
Pertec MyTape 800
(I think this is a QIC tape drive that connects via the floppy interface)
I thought QIC floppy connected tape drives were supported as well.
Quoted 2 lines
TEAC 1.44 3.5 inch Floppy FDR
(FD-235HF)
Standard 3.5" floppy drive?
Quoted 2 lines
Rocket Port 8-port serial board
(ISA, 8 - RJ11 jacks, made by Comtrol, brand-new in-box)
I know nothing about the support of the rest of the hardware.
Len Sorensen