Skip to contentSkip to conversation

Where's the list of needed hardware for donating?

DISCUSSION Richard Hubbell 3 participants 4 messages Jul 27, 2005 – Aug 2, 2005 2 messages not in the archive

lore
Share & tools
lore
#0 lore raw

Does a list exist describing the hardware needed or wished for to extend coverage for kernel development? I saw such a list at openbsd and thought it was a good idea.

Richard

#1 lore raw

Hi!

Quoted 3 lines

Does a list exist describing the hardware needed or wished for to extend coverage for kernel development? I saw such a list at openbsd and thought it was a good idea.

Heh, second zaurus for testing would certainly help ;-).
Pavel

Signature · 1 line
teflon -- maybe it is a trademark, but it should not be.
#4 lore raw
In reply to a message not in the archive

On 7/30/05, Pavel Machek <[email protected]> wrote:
-snip-snip-

Quoted 5 lines
Quoted 3 lines

The hardware I have may outdated/esoteric. I take it that there is
no such list then?
Maybe it's better not to support esoteric hardware.

Post a list somewhere...

Ok, here's the list:

Adaptec AHA-1510A
(ISA, centronix-style external connector with terminator, one internal ribbon cable,
I probably have some centronix-style external cables around too, this card doesn't have it's own boot ROM)

Gravis UltraSound a.k.a. GUS
(ISA, fully loaded with memory, 1megabyte (I think))

Pertec MyTape 800
(I think this is a QIC tape drive that connects via the floppy interface)

TEAC 1.44 3.5 inch Floppy FDR
(FD-235HF)

Rocket Port 8-port serial board
(ISA, 8 - RJ11 jacks, made by Comtrol, brand-new in-box)

#5 lore raw
Quoted 10 lines · Richard Hubbell

Ok, here's the list:

Adaptec AHA-1510A
(ISA, centronix-style external connector with terminator, one internal ribbon cable,
I probably have some centronix-style external cables around too, this card doesn't have it's own boot ROM)

Gravis UltraSound a.k.a. GUS
(ISA, fully loaded with memory, 1megabyte (I think))

Hasn't that been fully supported for years in ALSA? I remember the guy that started ALSA had written an amazing driver for the GUS before starting ALSA.

Quoted 2 lines

Pertec MyTape 800
(I think this is a QIC tape drive that connects via the floppy interface)

I thought QIC floppy connected tape drives were supported as well.

Quoted 2 lines

TEAC 1.44 3.5 inch Floppy FDR
(FD-235HF)

Standard 3.5" floppy drive?

Quoted 2 lines

Rocket Port 8-port serial board
(ISA, 8 - RJ11 jacks, made by Comtrol, brand-new in-box)

I know nothing about the support of the rest of the hardware.

Len Sorensen