arm: bcm: Enable reset and pinctrl for ARCH_BRCMSTB
Subsystems (3)
cover arm: bcm: Enable reset and pinctrl for ARCH_BRCMSTB
This patch series enabled PINCTRL and ARCH_HAS_RESET_CONTROLLER for ARCH_BRCMSTB since we have platforms that require these two subsystems.
Doug Berger (1):
ARM: bcm: Enable PINCTRL for ARCH_BRCMSTB
Jim Quinlan (1):
ARM: bcm: Enable ARCH_HAS_RESET_CONTROLLER for ARCH_BRCMSTB
arch/arm/mach-bcm/Kconfig | 2 ++ 1 file changed, 2 insertions(+)
Signature · 7 lines
2.17.1 _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
PATCH 1/2 ARM: bcm: Enable ARCH_HAS_RESET_CONTROLLER for ARCH_BRCMSTB
From: Jim Quinlan <[email protected]>
Allow the use of reset controllers on ARCH_BRCMSTB such as the recently introduced RESET_BRCMSTB driver.
--- arch/arm/mach-bcm/Kconfig | 1 + 1 file changed, 1 insertion(+)
arch/arm/mach-bcm/Kconfig +1 -0
@@ -208,6 +208,7 @@ config ARCH_BCM_63XX config ARCH_BRCMSTB bool "Broadcom BCM7XXX based boards" depends on ARCH_MULTI_V7 + select ARCH_HAS_RESET_CONTROLLER select ARM_GIC select ARM_ERRATA_798181 if SMP select HAVE_ARM_ARCH_TIMER
Signature · 7 lines
2.17.1 _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
PATCH 2/2 ARM: bcm: Enable PINCTRL for ARCH_BRCMSTB
In reply to Florian FainelliFrom: Doug Berger <[email protected]>
ARCH_BRCMSTB needs to use the BCM2835 pin controller for chips like BCM7211 which adopted that pin controller for GPIO.
--- arch/arm/mach-bcm/Kconfig | 1 + 1 file changed, 1 insertion(+)
arch/arm/mach-bcm/Kconfig +1 -0
@@ -219,6 +219,7 @@ config ARCH_BRCMSTB select ZONE_DMA if ARM_LPAE select SOC_BRCMSTB select SOC_BUS + select PINCTRL help Say Y if you intend to run the kernel on a Broadcom ARM-based STB chipset.
Signature · 7 lines
2.17.1 _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Quoted 8 lines · Florian Fainelli
This patch series enabled PINCTRL and
ARCH_HAS_RESET_CONTROLLERforARCH_BRCMSTBsince we have platforms that require these two subsystems.Doug Berger (1):
ARM: bcm: Enable PINCTRL forARCH_BRCMSTBJim Quinlan (1):
ARM: bcm: EnableARCH_HAS_RESET_CONTROLLERforARCH_BRCMSTB
Series applied to soc/next, thanks!
Signature · 7 lines
-- Florian _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel