Skip to contentSkip to conversation

ARM: dts: stm32: Enable PHY SSC on DH STM32MP13xx DHCOR DHSBC board

PATCH In review Marek Vasut 2 participants 2 messages Apr 11 – May 19

Subsystems (3)
lore
Share & tools
lore

Marek Vasut

author maintainer
#0 lore raw

PATCH 1/1 ARM: dts: stm32: Enable PHY SSC on DH STM32MP13xx DHCOR DHSBC board

Add realtek,rxc-ssc-enable and realtek,sysclk-ssc-enable to both PHY DT nodes to enable PHY Spread Spectrum on RXC and SYSCLK, CLKOUT is disabled and therefore does not need SSC enabled.

---
Cc: Alexandre Torgue <[email protected]>
Cc: Christoph Niedermaier <[email protected]>
Cc: Conor Dooley <[email protected]>
Cc: Krzysztof Kozlowski <[email protected]>
Cc: Maxime Coquelin <[email protected]>
Cc: Rob Herring <[email protected]>
Cc: [email protected]
Cc: [email protected]
Cc: [email protected]
Cc: [email protected]
Cc: [email protected]

---
 arch/arm/boot/dts/st/stm32mp135f-dhcor-dhsbc.dts | 4 ++++
 1 file changed, 4 insertions(+)
arch/arm/boot/dts/st/stm32mp135f-dhcor-dhsbc.dts +4 -0
index 9902849ed0406..70d85af467353 100644
@@ -97,6 +97,8 @@ ethphy1: ethernet-phy@1 {
 			interrupts = <12 IRQ_TYPE_LEVEL_LOW>;
 			reg = <1>;
 			realtek,clkout-disable;
+			realtek,rxc-ssc-enable;
+			realtek,sysclk-ssc-enable;
 			reset-assert-us = <15000>;
 			reset-deassert-us = <55000>;
 			reset-gpios = <&gpioa 11 GPIO_ACTIVE_LOW>;
@@ -146,6 +148,8 @@ ethphy2: ethernet-phy@1 {
 			interrupts = <15 IRQ_TYPE_LEVEL_LOW>;
 			reg = <1>;
 			realtek,clkout-disable;
+			realtek,rxc-ssc-enable;
+			realtek,sysclk-ssc-enable;
 			reset-assert-us = <15000>;
 			reset-deassert-us = <55000>;
 			reset-gpios = <&gpiog 8 GPIO_ACTIVE_LOW>;
Signature · 1 line
2.53.0
maintainer
#1 lore raw

Hi Marek

Quoted 35 lines · Marek Vasut

Add realtek,rxc-ssc-enable and realtek,sysclk-ssc-enable to both PHY DT nodes to enable PHY Spread Spectrum on RXC and SYSCLK, CLKOUT is disabled and therefore does not need SSC enabled.

---
Cc: Alexandre Torgue <[email protected]>
Cc: Christoph Niedermaier <[email protected]>
Cc: Conor Dooley <[email protected]>
Cc: Krzysztof Kozlowski <[email protected]>
Cc: Maxime Coquelin <[email protected]>
Cc: Rob Herring <[email protected]>
Cc: [email protected]
Cc: [email protected]
Cc: [email protected]
Cc: [email protected]
Cc: [email protected]

---
  arch/arm/boot/dts/st/stm32mp135f-dhcor-dhsbc.dts | 4 ++++
  1 file changed, 4 insertions(+)
arch/arm/boot/dts/st/stm32mp135f-dhcor-dhsbc.dts +2 -0
index 9902849ed0406..70d85af467353 100644
@@ -97,6 +97,8 @@ ethphy1: ethernet-phy@1 {
  			interrupts = <12 IRQ_TYPE_LEVEL_LOW>;
  			reg = <1>;
  			realtek,clkout-disable;
+			realtek,rxc-ssc-enable;
+			realtek,sysclk-ssc-enable;
  			reset-assert-us = <15000>;
  			reset-deassert-us = <55000>;
  			reset-gpios = <&gpioa 11 GPIO_ACTIVE_LOW>;

arch/arm/boot/dts/st/stm32mp135f-dhcor-dhsbc.dts ethphy2: ethernet-phy@1 { · line 155

Quoted 8 lines
arch/arm/boot/dts/st/stm32mp135f-dhcor-dhsbc.dts +2 -0
@@ -146,6 +148,8 @@ ethphy2: ethernet-phy@1 {
  			interrupts = <15 IRQ_TYPE_LEVEL_LOW>;
  			reg = <1>;
  			realtek,clkout-disable;
+			realtek,rxc-ssc-enable;
+			realtek,sysclk-ssc-enable;
  			reset-assert-us = <15000>;
  			reset-deassert-us = <55000>;
  			reset-gpios = <&gpiog 8 GPIO_ACTIVE_LOW>;

Applied on stm32-next.

Thanks
Alex