ARM/arm64: defconfig updates for Renesas platforms
Subsystems (2)
Geert Uytterhoeven
maintainercover ARM/arm64: defconfig updates for Renesas platforms
Hi all,
This patch series contains updates related to Renesas platforms for the various defconfig files.
I plan to qeueue these in renesas-devel-for-v6.4.
Thanks for your comments!
Geert Uytterhoeven (3):
ARM: shmobile: defconfig: Refresh for v6.3-rc1
ARM: multi_v7_defconfig: Enable additional support for RZ/N1 platforms
arm64: defconfig: Enable RZ/V2M xHCI and USB3.1 DRD controller support
arch/arm/configs/multi_v7_defconfig | 6 ++++++ arch/arm/configs/shmobile_defconfig | 2 ++ arch/arm64/configs/defconfig | 2 ++ 3 files changed, 10 insertions(+)
Signature · 17 lines
2.34.1
Gr{oetje,eeting}s,
Geert
--
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- [email protected]
In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
-- Linus Torvalds
_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernelGeert Uytterhoeven
maintainerPATCH 1/3 ARM: shmobile: defconfig: Refresh for v6.3-rc1
Refresh the defconfig for Renesas ARM systems:
- Disable CONFIG_SERIAL_8250_PCI1XXXX (No Microchip 8250 based serial
ports),
- Enable RZ/N1 USB Function controller support.
--- arch/arm/configs/shmobile_defconfig | 2 ++ 1 file changed, 2 insertions(+)
arch/arm/configs/shmobile_defconfig +2 -0
@@ -76,6 +76,7 @@ CONFIG_SERIAL_8250=y # CONFIG_SERIAL_8250_16550A_VARIANTS is not set CONFIG_SERIAL_8250_CONSOLE=y # CONFIG_SERIAL_8250_PCI is not set +# CONFIG_SERIAL_8250_PCI1XXXX is not set CONFIG_SERIAL_8250_DW=y CONFIG_SERIAL_8250_EM=y # CONFIG_SERIAL_8250_PERICOM is not set
@@ -168,6 +169,7 @@ CONFIG_USB_R8A66597_HCD=y CONFIG_USB_RENESAS_USBHS=y CONFIG_USB_GADGET=y CONFIG_USB_RENESAS_USBHS_UDC=y +CONFIG_USB_RENESAS_USBF=y CONFIG_USB_ETH=y CONFIG_MMC=y CONFIG_MMC_SDHI=y
Signature · 1 line
2.34.1
Geert Uytterhoeven
maintainerPATCH 2/3 ARM: multi_v7_defconfig: Enable additional support for RZ/N1 platforms
In reply to Geert UytterhoevenIncrease build and test coverage by enabling support for the A5PSW Ethernet switch, pin, watchdog, USB Function, RTC, and DMA mux controllers on the Renesas RZ/N1 SoC and the RZN1D-DB development board.
All drivers for the above are modular, except for the pin control driver.
--- arch/arm/configs/multi_v7_defconfig | 6 ++++++ 1 file changed, 6 insertions(+)
arch/arm/configs/multi_v7_defconfig +6 -0
@@ -251,6 +251,7 @@ CONFIG_B53_SPI_DRIVER=m CONFIG_B53_MDIO_DRIVER=m CONFIG_B53_MMAP_DRIVER=m CONFIG_NET_DSA_BCM_SF2=m +CONFIG_NET_DSA_RZN1_A5PSW=m CONFIG_SUN4I_EMAC=y CONFIG_SPI_AX88796C=m CONFIG_BCMGENET=m
@@ -474,6 +475,7 @@ CONFIG_PINCTRL_MSM8916=y CONFIG_PINCTRL_QCOM_SPMI_PMIC=y CONFIG_PINCTRL_QCOM_SSBI_PMIC=y CONFIG_PINCTRL_RZA2=y +CONFIG_PINCTRL_RZN1=y CONFIG_GPIO_ASPEED_SGPIO=y CONFIG_GPIO_DAVINCI=y CONFIG_GPIO_DWAPB=y
@@ -563,6 +565,7 @@ CONFIG_MESON_WATCHDOG=y CONFIG_DIGICOLOR_WATCHDOG=y CONFIG_RENESAS_WDT=m CONFIG_RENESAS_RZAWDT=m +CONFIG_RENESAS_RZN1WDT=m CONFIG_STPMIC1_WATCHDOG=y CONFIG_PM8916_WATCHDOG=m CONFIG_BCM47XX_WDT=y
@@ -873,6 +876,7 @@ CONFIG_USB_ISP1301=y CONFIG_USB_MXS_PHY=y CONFIG_USB_GADGET=y CONFIG_USB_RENESAS_USBHS_UDC=m +CONFIG_USB_RENESAS_USBF=m CONFIG_USB_ASPEED_VHUB=m CONFIG_USB_CONFIGFS=m CONFIG_USB_CONFIGFS_SERIAL=y
@@ -989,6 +993,7 @@ CONFIG_RTC_DRV_SH=m CONFIG_RTC_DRV_PL031=y CONFIG_RTC_DRV_AT91RM9200=m CONFIG_RTC_DRV_AT91SAM9=m +CONFIG_RTC_DRV_RZN1=m CONFIG_RTC_DRV_VT8500=y CONFIG_RTC_DRV_SUNXI=y CONFIG_RTC_DRV_MV=y
@@ -1020,6 +1025,7 @@ CONFIG_UNIPHIER_MDMAC=y CONFIG_XILINX_DMA=y CONFIG_QCOM_BAM_DMA=y CONFIG_DW_DMAC=y +CONFIG_RZN1_DMAMUX=m CONFIG_RCAR_DMAC=y CONFIG_RENESAS_USB_DMAC=m CONFIG_VIRTIO_PCI=y
Signature · 1 line
2.34.1
Geert Uytterhoeven
maintainerPATCH 3/3 arm64: defconfig: Enable RZ/V2M xHCI and USB3.1 DRD controller support
In reply to Geert UytterhoevenIncrease build and test coverage by enabling RZ/V2M xHCI and USB3.1 DRD controller support.
Note that the latter cannot be modular, as USB_XHCI_RCAR is builtin.
--- arch/arm64/configs/defconfig | 2 ++ 1 file changed, 2 insertions(+)
arch/arm64/configs/defconfig +2 -0
@@ -908,6 +908,7 @@ CONFIG_USB=y CONFIG_USB_OTG=y CONFIG_USB_XHCI_HCD=y CONFIG_USB_XHCI_PCI_RENESAS=m +CONFIG_USB_XHCI_RZV2M=y CONFIG_USB_XHCI_TEGRA=y CONFIG_USB_BRCMSTB=m CONFIG_USB_EHCI_HCD=y
@@ -943,6 +944,7 @@ CONFIG_USB_ONBOARD_HUB=m CONFIG_NOP_USB_XCEIV=y CONFIG_USB_GADGET=y CONFIG_USB_RENESAS_USBHS_UDC=m +CONFIG_USB_RZV2M_USB3DRD=y CONFIG_USB_RENESAS_USB3=m CONFIG_USB_TEGRA_XUDC=m CONFIG_USB_CONFIGFS=m
Signature · 7 lines
2.34.1 _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel