Porting custom board from u-boot 1.0.1 to u-boot 1.1.2
I'm working on the Metrowerks "QUICCstart 8540 Evaluation System" which is provided with u-boot 1.0.1 (custom board configuration called EVAL8540). I have got the source code from the installation CD and want to port it to the latest u-boot version.
To do that I would like to know the changes which occured between this two version of the u-boot project and what do I have to adapt in the source code of the EVAL8540 configuration.
PS: I already installed the ELDK 3.1 on my Linux PC.
Best regards and thanks in advance,
Armand
[U-Boot-Users] smc91111 and MII
Evening (o;
Is this a generic behaviour among all ethernet drivers that it get's reset every time before it is used like the smc91111?
So we just block ourself out to use the MII commands although functions are in the driver ready to be used (with some slight modifications ;o).
best regards
rick
Quoted 1 line · In message <[email protected]> you wrote:
I'm working on the Metrowerks "QUICCstart 8540 Evaluation System" which
Please bear with my ignorance, but is this different from the MPC8540ADS board?
Quoted 2 lines
To do that I would like to know the changes which occured between this two version of the u-boot project and what do I have to adapt in the
Identify which specific version the port was based on, and then use "cvs diff". You may also want to run "cvsps" to break the changes down into patchsets. See also the CHANGELOG file for documentation about changes.
Best regards,
Wolfgang Denk
Signature · 4 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de People are always a lot more complicated than you think. It's very important to remember that. - Terry Pratchett, _Truckers_
Quoted 5 lines · Wolfgang Denk
Quoted 1 line · In message <[email protected]> you wrote:
I'm working on the Metrowerks "QUICCstart 8540 Evaluation System" which
Please bear with my ignorance, but is this different from the MPC8540ADS board?
The main difference I noticed in the hardware parts are:
MPC8540ADS Metrowerks boards
Flash
32bit 16bit 16MB 8MB ? Intel 28F640J3
SDRAM
64 MB no SDRAM
DDR
128 MB 256 MB
Quoted 13 lines
Quoted 3 lines
To do that I would like to know the changes which occured between this two version of the u-boot project and what do I have to adapt in the
Identify which specific version the port was based on, and then use "cvs diff". You may also want to run "cvsps" to break the changes down into patchsets. See also the CHANGELOG file for documentation about changes.
Best regards,
Wolfgang Denk
Quoted 5 lines · In message <[email protected]> you wrote:
Quoted 3 lines
Please bear with my ignorance, but is this different from the MPC8540ADS board?
The main difference I noticed in the hardware parts are:
I see. Consider it a new port, then.
Best regards,
Wolfgang Denk
Signature · 4 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de For every complex problem, there is a solution that is simple, neat, and wrong. -- H. L. Mencken