pci problem with arm-integrator AP and linux 2.6
I'm having some trouble on running linux with PCI support on my ARM integrator board.
If I do not put PCI support on the kernel configuration, the kernel starts and everything works fine, if I just enable the PCI support the kernel stuck somewhere.
Somebody has an idea on where is the problem ?
Thanks,
Thierry Matalini
Quoted 6 lines · Thierry Matalini
I'm having some trouble on running linux with PCI support on my ARM integrator board.
If I do not put PCI support on the kernel configuration, the kernel starts and everything works fine, if I just enable the PCI support the kernel stuck somewhere.
Is this U-Boot related? If not, you could try the ARM Linux Kernel mailing list (and add a bit more details like the full kernel version).
Catalin
Quoted 2 lines · In message <[email protected]> you wrote:
I'm having some trouble on running linux with PCI support on my ARM integrator board.
And what exactly was yourt U-Boot problem?
This mailing list is for U-Boot related questions only.
Best regards,
Wolfgang Denk
Signature · 4 lines
See us @ Embedded World, Nuremberg, Feb 22 - 24, Hall 10.0 Booth 310 Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de Leave bigotry in your quarters; there's no room for it on the bridge. -- Kirk, "Balance of Terror", stardate 1709.2