Skip to contentSkip to conversation

pci problem with arm-integrator AP and linux 2.6

U-Boot-Users Thierry Matalini 3 participants 3 messages Feb 23, 2005 – Feb 24, 2005

lore
Share & tools
lore
#0 lore raw

I'm having some trouble on running linux with PCI support on my ARM integrator board.

If I do not put PCI support on the kernel configuration, the kernel starts and everything works fine, if I just enable the PCI support the kernel stuck somewhere.

Somebody has an idea on where is the problem ?

Thanks,
Thierry Matalini

#1 lore raw
Quoted 6 lines · Thierry Matalini

I'm having some trouble on running linux with PCI support on my ARM integrator board.

If I do not put PCI support on the kernel configuration, the kernel starts and everything works fine, if I just enable the PCI support the kernel stuck somewhere.

Is this U-Boot related? If not, you could try the ARM Linux Kernel mailing list (and add a bit more details like the full kernel version).

Catalin

#2 lore raw
In reply to Thierry Matalini
Quoted 2 lines · In message <[email protected]> you wrote:

I'm having some trouble on running linux with PCI support on my ARM integrator board.

And what exactly was yourt U-Boot problem?

This mailing list is for U-Boot related questions only.

Best regards,

Wolfgang Denk

Signature · 4 lines
See us @ Embedded World, Nuremberg, Feb 22 - 24,  Hall 10.0 Booth 310
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Leave bigotry in your quarters; there's no room for it on the bridge.
	-- Kirk, "Balance of Terror", stardate 1709.2