Skip to contentSkip to conversation

U-boot not starting - sometimes

U-Boot-Users Martin Egholm Nielsen 2 participants 3 messages Nov 25, 2005

lore
Share & tools
lore
#0 lore raw

Hi,

We have encountered on some of our 405EP boards that when powered on nothing happens - U-boot doesn't start.
Powering off and trying again it "suddenly" works...

When caught in this "not-booting-state", it doesn't even help to activate the reset-pin. However, in the attached serial console, some giberish characters do come out (5-10 chars.).

Now, having seen problems with the memory chips on some of my boards, I was wondering if this could be a similar problem?

Best regards,
Martin Egholm

#1 lore raw
Quoted 3 lines · In message <[email protected]> you wrote:

Now, having seen problems with the memory chips on some of my boards, I was wondering if this could be a similar problem?

Check your voltages (and their power-on sequence) and especially the clocks.

Best regards,

Wolfgang Denk

Signature · 4 lines
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
"It may be that our role on this planet is not to worship God but  to
create him."                                       - Arthur C. Clarke
#2 lore raw

Hi,

Quoted 4 lines
Quoted 2 lines

Now, having seen problems with the memory chips on some of my boards, I was wondering if this could be a similar problem?

Check your voltages (and their power-on sequence) and especially the clocks.

We have tried with two different power-up sequences, and have the same result...
Going even more OT: Do you actually know the most optimal powerup sequence for the 405EP? Because the datasheat doesn't specify...

Thx,
Martin