U-boot not starting - sometimes
Hi,
We have encountered on some of our 405EP boards that when powered on nothing happens - U-boot doesn't start.
Powering off and trying again it "suddenly" works...
When caught in this "not-booting-state", it doesn't even help to activate the reset-pin. However, in the attached serial console, some giberish characters do come out (5-10 chars.).
Now, having seen problems with the memory chips on some of my boards, I was wondering if this could be a similar problem?
Best regards,
Martin Egholm
Quoted 3 lines · In message <[email protected]> you wrote:
Now, having seen problems with the memory chips on some of my boards, I was wondering if this could be a similar problem?
Check your voltages (and their power-on sequence) and especially the clocks.
Best regards,
Wolfgang Denk
Signature · 4 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de "It may be that our role on this planet is not to worship God but to create him." - Arthur C. Clarke
Hi,
Quoted 4 lines
Quoted 2 lines
Now, having seen problems with the memory chips on some of my boards, I was wondering if this could be a similar problem?
Check your voltages (and their power-on sequence) and especially the clocks.
We have tried with two different power-up sequences, and have the same result...
Going even more OT: Do you actually know the most optimal powerup sequence for the 405EP? Because the datasheat doesn't specify...
Thx,
Martin