Skip to contentSkip to conversation

Bluetooth: btusb: Add gpio reset way for qca btsoc in cmd_timeout

PATCH In review [email protected] 2 participants 2 messages Sep 16, 2021 – Sep 21, 2021

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 Bluetooth: btusb: Add gpio reset way for qca btsoc in cmd_timeout

if platform provide gpio connect to BT_EN reset pin of qca btsoc chip, we can do hardware reset instead of usb port reset.

---
 drivers/bluetooth/btusb.c | 22 ++++++++++++++++++++++
 1 file changed, 22 insertions(+)
drivers/bluetooth/btusb.c +22 -0
index 8ef4e0f6e0bb..da85cc14f931 100644
@@ -657,11 +657,33 @@ static void btusb_rtl_cmd_timeout(struct hci_dev *hdev)
 static void btusb_qca_cmd_timeout(struct hci_dev *hdev)
 {
 	struct btusb_data *data = hci_get_drvdata(hdev);
+	struct gpio_desc *reset_gpio = data->reset_gpio;
 	int err;
 
 	if (++data->cmd_timeout_cnt < 5)
 		return;
 
+	if (reset_gpio) {
+		bt_dev_err(hdev, "Reset qca device via bt_en gpio");
+
+		/* Toggle the hard reset line. The qca bt device is going to
+		 * yank itself off the USB and then replug. The cleanup is handled
+		 * correctly on the way out (standard USB disconnect), and the new
+		 * device is detected cleanly and bound to the driver again like
+		 * it should be.
+		 */
+		if (test_and_set_bit(BTUSB_HW_RESET_ACTIVE, &data->flags)) {
+			bt_dev_err(hdev, "last reset failed? Not resetting again");
+			return;
+		}
+
+		gpiod_set_value_cansleep(reset_gpio, 0);
+		msleep(200);
+		gpiod_set_value_cansleep(reset_gpio, 1);
+
+		return;
+	}
+
 	bt_dev_err(hdev, "Multiple cmd timeouts seen. Resetting usb device.");
 	/* This is not an unbalanced PM reference since the device will reset 

*/
err = usb_autopm_get_interface(data->intf);

Signature · 1 line
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum, a Linux Foundation Collaborative Project
maintainer
#1 lore raw

Hi Tim,

Quoted 7 lines

if platform provide gpio connect to BT_EN reset pin of qca btsoc chip, we can do hardware reset instead of usb port reset.

---
drivers/bluetooth/btusb.c | 22 ++++++++++++++++++++++

1 file changed, 22 insertions(+)

patch has been applied to bluetooth-next tree.

Regards

Marcel