Bluetooth: btusb: Add gpio reset way for qca btsoc in cmd_timeout
Subsystems (2)
PATCH 1/1 Bluetooth: btusb: Add gpio reset way for qca btsoc in cmd_timeout
if platform provide gpio connect to BT_EN reset pin of qca btsoc chip, we can do hardware reset instead of usb port reset.
Signed-off-by Tim Jiang <[email protected]>
--- drivers/bluetooth/btusb.c | 22 ++++++++++++++++++++++ 1 file changed, 22 insertions(+)
drivers/bluetooth/btusb.c +22 -0
@@ -657,11 +657,33 @@ static void btusb_rtl_cmd_timeout(struct hci_dev *hdev)static void btusb_qca_cmd_timeout (struct hci_dev *hdev) {struct btusb_data *data =hci_get_drvdata (hdev); +struct gpio_desc *reset_gpio = data->reset_gpio;int err;if (++data->cmd_timeout_cnt <5 )return ; +if (reset_gpio) { +bt_dev_err (hdev,"Reset qca device via bt_en gpio" ); + +/* Toggle the hard reset line. The qca bt device is going to +* yank itself off the USB and then replug. The cleanup is handled +* correctly on the way out (standard USB disconnect), and the new +* device is detected cleanly and bound to the driver again like +* it should be. +*/ +if (test_and_set_bit (BTUSB_HW_RESET_ACTIVE , &data->flags)) { +bt_dev_err (hdev,"last reset failed? Not resetting again" ); +return ; + } + +gpiod_set_value_cansleep (reset_gpio,0 ); +msleep (200 ); +gpiod_set_value_cansleep (reset_gpio,1 ); + +return ; + } +bt_dev_err (hdev,"Multiple cmd timeouts seen. Resetting usb device." );/* This is not an unbalanced PM reference since the device will reset
*/
err = usb_autopm_get_interface(data->intf);
Signature · 1 line
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum, a Linux Foundation Collaborative Project
Marcel Holtmann
maintainerHi Tim,
Quoted 7 lines
if platform provide gpio connect to
BT_ENreset pin of qca btsoc chip, we can do hardware reset instead of usb port reset.Signed-off-by Tim Jiang <[email protected]>---
drivers/bluetooth/btusb.c| 22 ++++++++++++++++++++++1 file changed, 22 insertions(+)
patch has been applied to bluetooth-next tree.
Regards
Marcel