HTB: child rate > parent rate
In his htb manual Devik writes:
"... The rate supplied for a parent should be the sum of the rates of its children. (We may later describe how it can be useful to violate this rule.)"
As far as I can tell this is not described anywhere.
Does it have any negative consequences to have child classes with higher rate/ceil than their parent when I'm using "inject 0"?
Thanks in advance!
~Andreas
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
I case of injecting the rate can be higher. However if I ever finish new/faster version, injecting will not be supported as it is very hard to implement (unfortunately).
Quoted 10 lines · Andreas Lehrbaum
In his htb manual Devik writes:
"... The rate supplied for a parent should be the sum of the rates of its children. (We may later describe how it can be useful to violate this rule.)"
As far as I can tell this is not described anywhere.
Does it have any negative consequences to have child classes with higher rate/ceil than their parent when I'm using "inject 0"?
Quoted 8 lines
Thanks in advance!
~Andreas
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/