Skip to contentSkip to conversation

Linux CBQ question

LARTC Stef Coene 1 participant 1 message May 1, 2002

lore
Share & tools
lore

Stef Coene

author
#0 lore raw
Quoted 12 lines · Udayan Borkar

Hi,

Question on Linux-CBQ. I have a Pentium 4 based PC running Redhat 7.2 (kernel 2.4.7) with 2 100-Base T ethernet interfaces (Eth0, Eth1). Traffic received on Eth0 is sent out on Eth1.

I am trying to restrict the outgoing traffic rate on Eth1 to 50Mbits/sec. However, when I use the configuration below, I find that the rate on Eth1 is about 5 Mbits/sec. If I delete the keywords bounded, isolated, I get a rate of 90 Mbits/sec. Measurements were made over an interval of 15 sec to 1 min)

Quoted 7 lines

On trying other Minburst, Maxburst values, the rate changes (e.g. Maxburst = 300, Minburst = 70) produces 25Mbits/sec etc.

(I was trying to create a hierarchy of classes whose total rate needs to be limited to 50Mbits/sec, I have managed to reduce the problem from that to this simplified configuration. I would prefer not to use HTB at the moment).

You can do it also with CBQ. But you have to be carefull by choosing the parameters.

Quoted 3 lines

Can someone take a quick look at the configuration below and tell me what I am doing wrong? (Ip address of Eth0=10.1.1.2, netmask=255.255.255.0; Eth1=10.1.2.2,netmask=255.255.255.0)

The commands seems ok to me. I tried to bound the outgoing traffic on a 10mbit card and I had some good results
(http://www.docum.org/stef.coene/qos/tests/cbq/bounded/bounded.html). But I also found that the isolated parameter is not working and can distrub the setup. So, can you try again with only the bounded and no isolated parameter ?

Stef

Signature · 7 lines
[email protected]
 "Using Linux as bandwidth manager"
     http://www.docum.org/
     #lartc @ irc.openprojects.net
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/