Linux CBQ question
Quoted 12 lines · Udayan Borkar
Hi,
Question on Linux-CBQ. I have a Pentium 4 based PC running Redhat 7.2 (kernel 2.4.7) with 2 100-Base T ethernet interfaces (Eth0, Eth1). Traffic received on Eth0 is sent out on Eth1.
I am trying to restrict the outgoing traffic rate on Eth1 to 50Mbits/sec. However, when I use the configuration below, I find that the rate on Eth1 is about 5 Mbits/sec. If I delete the keywords bounded, isolated, I get a rate of 90 Mbits/sec. Measurements were made over an interval of 15 sec to 1 min)
Quoted 7 lines
On trying other Minburst, Maxburst values, the rate changes (e.g. Maxburst = 300, Minburst = 70) produces 25Mbits/sec etc.
(I was trying to create a hierarchy of classes whose total rate needs to be limited to 50Mbits/sec, I have managed to reduce the problem from that to this simplified configuration. I would prefer not to use HTB at the moment).
You can do it also with CBQ. But you have to be carefull by choosing the parameters.
Quoted 3 lines
Can someone take a quick look at the configuration below and tell me what I am doing wrong? (Ip address of Eth0=10.1.1.2, netmask=255.255.255.0; Eth1=10.1.2.2,netmask=255.255.255.0)
The commands seems ok to me. I tried to bound the outgoing traffic on a 10mbit card and I had some good results
(http://www.docum.org/stef.coene/qos/tests/cbq/bounded/bounded.html). But I also found that the isolated parameter is not working and can distrub the setup. So, can you try again with only the bounded and no isolated parameter ?
Stef
Signature · 7 lines
[email protected] "Using Linux as bandwidth manager" http://www.docum.org/ #lartc @ irc.openprojects.net _______________________________________________ LARTC mailing list / [email protected] http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/