Skip to contentSkip to conversation

I: troubles with RIPd

LARTC Andreani Luca 1 participant 1 message Jun 14, 2002

lore
Share & tools
lore
#0 lore raw
Quoted 40 lines

Hi,

I'm trying to test RIP but I have some problems:

1. I connect two linux boxes running zebra and ripd, with a cross
ethernet cable.

looking at the sniffer (ethereal) all seems to go well, because I
can see both boxes sending the Ripv2 response message in broadcast
and receiving them. The fact is that on both the ripd.conf file I put the
command "redistribute kernel" but only one box updates its routing
table. Why the other box doesn't?

2. Substituting one of the linux boxes with a cisco2600 router, things
get worst. The cisco router send a ripv2 request packet and then
continues to send CDP packets without redistributing its static routes.
Does anybady know a simple configuration for the cisco2600 rip? On
cisco web siteI found all but this.

my zebra.conf:

hostname Router-A
password zebra
enable password zebra
interface lo
description Router-A loopback
ip route 0.0.0.0/0 192.168.100.1
log file zebra.log

my ripd.conf

hostname ripd-r1
password zebra
router rip
network 192.168.100.0/24
redistribute kernel
log stdout

my cisco configuration

Quoted 8 lines

router rip
version 2
network 192.168.100.0
redistribute static

Many thanks for help,

Luca Andreani

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/