I: troubles with RIPd
Quoted 40 lines
Hi,
I'm trying to test RIP but I have some problems:
1. I connect two linux boxes running zebra and ripd, with a cross
ethernet cable.looking at the sniffer (ethereal) all seems to go well, because I
can see both boxes sending the Ripv2 response message in broadcast
and receiving them. The fact is that on both the ripd.conf file I put the
command "redistribute kernel" but only one box updates its routing
table. Why the other box doesn't?2. Substituting one of the linux boxes with a cisco2600 router, things
get worst. The cisco router send a ripv2 request packet and then
continues to send CDP packets without redistributing its static routes.
Does anybady know a simple configuration for the cisco2600 rip? On
cisco web siteI found all but this.my zebra.conf:
hostname Router-A
password zebra
enable password zebra
interface lo
description Router-A loopback
ip route 0.0.0.0/0 192.168.100.1
log file zebra.logmy ripd.conf
hostname ripd-r1
password zebra
router rip
network 192.168.100.0/24
redistribute kernel
log stdoutmy cisco configuration
Quoted 8 lines
router rip
version 2
network 192.168.100.0
redistribute staticMany thanks for help,
Luca Andreani
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/