advanced routing for traffic generator-like setup
Hi,
Given the following two variations of the same setup:
HostA ------------------ HostB
eth0: eth0: 1.1.1.1/24 1.1.1.2/24 2.2.2.1/24 2.2.2.2/24
and:
HostA HostB
eth0:1.1.1.1/24 ------------ eth0:1.1.1.2/24 eth1:2.2.2.1/24 ------------ eth1:2.2.2.2/24
(basically same setup but with two NICs on each host)
How does one set up advanced routing so that when HostA sends a packet from 1.1.1.1 to 2.2.2.1, it goes via HostB, and vice versa: a packet from 2.2.2.1 to 1.1.1.1 also goes via HostB.
This setup would allow me to do traffic-generator/ troughput-like tests when HostB is a low-end machine.
I have been fiddling around with ip route/ip rule, but the biggest problem I seem te be having is that when I change/delete an entry from the local table, HostA no longer replies to ARP queries on the wire.
Thanks in advance,
Filip
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
Quoted 4 lines · Filip Sneppe
How does one set up advanced routing so that when HostA sends a packet from 1.1.1.1 to 2.2.2.1, it goes via HostB, and vice versa: a packet from 2.2.2.1 to 1.1.1.1 also goes via HostB.
Only by doing NAT at HostB. Linux is way to smart for this to work otherwise :-)
Regards,
bert
Signature · 6 lines
http://www.PowerDNS.com Versatile DNS Software & Services http://www.tk the dot in .tk http://lartc.org Linux Advanced Routing & Traffic Control HOWTO _______________________________________________ LARTC mailing list / [email protected] http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
You can enable Zebra routing because both host are in different networks maybe ripd a possible solution this issue
http://www.guadawireless.net
-.-.LievenX..--.
----- Mensaje Original -----
De: bert hubert <[email protected]>
Fecha: Jueves, Julio 4, 2002 4:49 pm
Asunto: Re: [LARTC] advanced routing for traffic generator-like setup
Quoted 7 lines · Filip Sneppe
Quoted 5 lines
How does one set up advanced routing so that when HostA sends a packet from 1.1.1.1 to 2.2.2.1, it goes via HostB, and vice versa: a packet from 2.2.2.1 to 1.1.1.1 also goes via HostB.
Quoted 16 lines
Only by doing NAT at HostB. Linux is way to smart for this to work otherwise:-)
Regards,
bert
Signature · 7 lines
http://www.PowerDNS.com Versatile DNS Software & Services http://www.tk the dot in .tk http://lartc.org Linux Advanced Routing & Traffic Control HOWTO _______________________________________________ LARTC mailing list / [email protected] http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
begin:vcard
n:;LievenX
version:2.1
end:vcard