Skip to contentSkip to conversation

advanced routing for traffic generator-like setup

LARTC Filip Sneppe 3 participants 3 messages Jul 1, 2002 – Jul 4, 2002

lore
Share & tools
lore
#0 lore raw

Hi,

Given the following two variations of the same setup:

HostA ------------------ HostB

 eth0:               eth0:
 1.1.1.1/24          1.1.1.2/24
 2.2.2.1/24          2.2.2.2/24

and:

HostA HostB
eth0:1.1.1.1/24 ------------ eth0:1.1.1.2/24 eth1:2.2.2.1/24 ------------ eth1:2.2.2.2/24

(basically same setup but with two NICs on each host)

How does one set up advanced routing so that when HostA sends a packet from 1.1.1.1 to 2.2.2.1, it goes via HostB, and vice versa: a packet from 2.2.2.1 to 1.1.1.1 also goes via HostB.

This setup would allow me to do traffic-generator/ troughput-like tests when HostB is a low-end machine.

I have been fiddling around with ip route/ip rule, but the biggest problem I seem te be having is that when I change/delete an entry from the local table, HostA no longer replies to ARP queries on the wire.

Thanks in advance,
Filip

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#1 lore raw
Quoted 4 lines · Filip Sneppe

How does one set up advanced routing so that when HostA sends a packet from 1.1.1.1 to 2.2.2.1, it goes via HostB, and vice versa: a packet from 2.2.2.1 to 1.1.1.1 also goes via HostB.

Only by doing NAT at HostB. Linux is way to smart for this to work otherwise :-)

Regards,

bert

Signature · 6 lines
http://www.PowerDNS.com          Versatile DNS Software & Services
http://www.tk                              the dot in .tk
http://lartc.org           Linux Advanced Routing & Traffic Control HOWTO
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
#2 lore raw
In reply to Filip Sneppe

You can enable Zebra routing because both host are in different networks maybe ripd a possible solution this issue

http://www.guadawireless.net
-.-.LievenX..--.

----- Mensaje Original -----
De: bert hubert <[email protected]>
Fecha: Jueves, Julio 4, 2002 4:49 pm
Asunto: Re: [LARTC] advanced routing for traffic generator-like setup

Quoted 7 lines · Filip Sneppe
Quoted 5 lines

How does one set up advanced routing so that when HostA sends a packet from 1.1.1.1 to 2.2.2.1, it goes via HostB, and vice versa: a packet from 2.2.2.1 to 1.1.1.1 also goes via HostB.

Quoted 16 lines

Only by doing NAT at HostB. Linux is way to smart for this to work otherwise:-)

Regards,

bert

Signature · 7 lines
http://www.PowerDNS.com          Versatile DNS Software & Services
http://www.tk                              the dot in .tk
http://lartc.org           Linux Advanced Routing & Traffic 
Control HOWTO
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

begin:vcard
n:;LievenX
version:2.1
end:vcard