non-ethernet devices and QoS ?
hi,
I'm just evaluating to use Cyclades PC300 card instead of a Cisco router... and 'cause I have never used such boards so I wanted to know will I be able to do egress shaping on this board ? (It should be connected to the ISP with FrameRelay protocol (V35)) ... and as far as I can understand it will be seen in linux as hdslN device !! (not sure).
So will I be able to work with it as a normal ethernet device ?!
Sorry for the stupid question, but I have to be sure it will work
thanx alot
raptor
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
Hi,
if I known there is no problem with QoS on Synchronnous card. The devices are hdlc0, hdlc1...
BUT frame-relay use own tools for QoS on provider side, it's known as signaling. You will have problem e.g. with latency because frame-relay have own strategy with prioritization of traffic.
For more read www.frforum.com
Quoted 9 lines · On Fri, 9 Aug 2002 [email protected] wrote:
hi,
I'm just evaluating to use Cyclades PC300 card instead of a Cisco router... and 'cause I have never used such boards so I wanted to know will I be able to do egress shaping on this board ?
(It should be connected to the ISP with FrameRelay protocol (V35)) ... and as far as I can understand it will be seen in linux as hdslN device !! (not sure).
Quoted 6 lines
So will I be able to work with it as a normal ethernet device ?!
Sorry for the stupid question, but I have to be sure it will work
thanx alot
raptor
--
`)_|_(' PSIkappa
I k psi _at_ atlantis.sk
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/