Skip to contentSkip to conversation

non-ethernet devices and QoS ?

LARTC [email protected] 2 participants 2 messages Aug 9, 2002 – Aug 10, 2002

lore
Share & tools
lore
#0 lore raw

hi,

I'm just evaluating to use Cyclades PC300 card instead of a Cisco router... and 'cause I have never used such boards so I wanted to know will I be able to do egress shaping on this board ? (It should be connected to the ISP with FrameRelay protocol (V35)) ... and as far as I can understand it will be seen in linux as hdslN device !! (not sure).

So will I be able to work with it as a normal ethernet device ?!

Sorry for the stupid question, but I have to be sure it will work

thanx alot
raptor
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#1 lore raw

Hi,
if I known there is no problem with QoS on Synchronnous card. The devices are hdlc0, hdlc1...
BUT frame-relay use own tools for QoS on provider side, it's known as signaling. You will have problem e.g. with latency because frame-relay have own strategy with prioritization of traffic.
For more read www.frforum.com

Quoted 9 lines · On Fri, 9 Aug 2002 [email protected] wrote:

hi,

I'm just evaluating to use Cyclades PC300 card instead of a Cisco router... and 'cause I have never used such boards so I wanted to know will I be able to do egress shaping on this board ?
(It should be connected to the ISP with FrameRelay protocol (V35)) ... and as far as I can understand it will be seen in linux as hdslN device !! (not sure).

Quoted 6 lines

So will I be able to work with it as a normal ethernet device ?!

Sorry for the stupid question, but I have to be sure it will work

thanx alot
raptor

--
`)_|_(' PSIkappa
I k psi _at_ atlantis.sk

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/