Skip to contentSkip to conversation

load balancing without NAT

LARTC Bartek Krajnik 2 participants 2 messages Feb 6, 2003

lore
Share & tools
lore
#0 lore raw

I have eth0 (isp1, internet), eth1 (isp2, internet) and eth2 for my LAN

eth0 (isp1)

           \
            Linux - eth2 (LAN)
           /

eth1 (isp2)

I need for every connection (not packet) load balancing - TCP sessions must be kept. For example: first connection from LAN goes through eth0, second through eth1, third through eth0 ... I can't change anything on the other site of eth0 and eth1.

This explains idea (but is with NAT - I need without):
http://www.linuxvirtualserver.org/~julian/nano.txt

Signature · 9 lines
GPG-Key:
   http://www.bartek.bicom.pl/public_key.txt
   pub  1024D/948DE45D 2002-12-12 Bartek Krajnik <[email protected]>
   Primary key fingerprint: 95E9 8E2D 1801 7864 2244  6EAA 03E5 764D 948D E45D


_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
#1 lore raw
Quoted 8 lines · Bartek Krajnik

I have eth0 (isp1, internet), eth1 (isp2, internet) and eth2 for my LAN

eth0 (isp1)

           \
            Linux - eth2 (LAN)
           /

eth1 (isp2)

Quoted 7 lines

I need for every connection (not packet) load balancing - TCP sessions must be kept. For example: first connection from LAN goes through eth0, second through eth1, third through eth0 ... I can't change anything on the other site of eth0 and eth1.

This explains idea (but is with NAT - I need without):
http://www.linuxvirtualserver.org/~julian/nano.txt

As far as I know, you need NAT. So you are out of luck.

Stef

Signature · 8 lines
[email protected]
 "Using Linux as bandwidth manager"
     http://www.docum.org/
     #lartc @ irc.oftc.net

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/