Bridge+QOS
Hi all
iam setting up a bridge with QOS Services
i would like to you to have coments on setup, is this works
i ahve setup like this
LAN--eth1(Bridge)eth0--router--Internet
in LAN i have users 10 people
i would like to have QOS Services for 5 people burstable 5 People commited ( bounded b/w what i have)
Can i use TC+htb to make this setup
is the tc+htb work with my transparent bridge
thanks
hare
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
Quoted 9 lines · hare ram
Hi all
iam setting up a bridge with QOS Services
i would like to you to have coments on setup, is this works
i ahve setup like this
Quoted 8 lines
LAN--eth1(Bridge)eth0--router--Internet
in LAN i have users 10 people
i would like to have QOS Services for 5 people burstable 5 People commited ( bounded b/w what i have)Can i use TC+htb to make this setup
yes
Quoted 1 line
is the tc+htb work with my transparent bridge
yes.
You have to shape on eth0 and eth1. Just like you should do on a normal router.
Stef
Signature · 8 lines
[email protected] "Using Linux as bandwidth manager" http://www.docum.org/ #lartc @ irc.oftc.net _______________________________________________ LARTC mailing list / [email protected] http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
Works very well. Have been using it for 8 months so. Bridging provides transparency on network and does not affect the tc operation in any manner. If you want marking of packets and routing based on fwmark, then you'll have to juggle a bit as the packet flow in a bridge is different from that of a router. Marking is possible only on the FORWARD Chain/table. Alternatively, you can force packets thro' iptables chains
- prerouting, nat, input, forward, postrouting, output using ebtables. I'm not sure if ebtables can mark packets. Have not looked deep enough.
Mohan
-----Original Message-----
From: [email protected] [mailto:[email protected]] On Behalf Of hare ram
Sent: Monday, March 17, 2003 12:35 PM
To: [email protected]
Subject: [LARTC] Bridge+QOS
Hi all
iam setting up a bridge with QOS Services
i would like to you to have coments on setup, is this works
i ahve setup like this
LAN--eth1(Bridge)eth0--router--Internet
in LAN i have users 10 people
i would like to have QOS Services for 5 people burstable 5 People commited ( bounded b/w what i have)
Can i use TC+htb to make this setup
is the tc+htb work with my transparent bridge
thanks
hare
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/