Skip to contentSkip to conversation

IP Telephony with HTB or IMQ

LARTC Chijioke Kalu 2 participants 4 messages Jul 5, 2003

lore
Share & tools
lore
#0 lore raw

Hello all,

Please, does anyone have a setup where HTB or IMQ was used to set aside uplink/downlink speed for IP Telephony, in other to have clear voice quality?

K

_________________________________________________________________
Add photos to your messages with MSN 8. Get 2 months FREE*.
http://join.msn.com/?pageþatures/featuredemail

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#1 lore raw

Don't expect good quality if use local QoS for incomming data. To have real non-best effort you need to have QoS on both sides of link - when transmitting packets. Then yes - HTB should be able to do it using priorities. But I doubd you can do it if IMQ is in the way. devik

Quoted 8 lines · Chijioke Kalu

Hello all,

Please, does anyone have a setup where HTB or IMQ was used to set aside uplink/downlink speed for IP Telephony, in other to have clear voice quality?

K

Quoted 10 lines

_________________________________________________________________
Add photos to your messages with MSN 8. Get 2 months FREE*.
http://join.msn.com/?pageþatures/featuredemail

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#2 lore raw
In reply to Chijioke Kalu

Ok by me, am just desperate, after reading the documentation and tried differing configs, i was not successful, thus decided to ask experts, I will wait till monday

thank you

--------------------------------
Sorry I answer some mails if it is under 30seconds or so. I have no time to write/test such config but I'm sure someone will do it at least at Monday.
devik

Quoted 3 lines · Chijioke Kalu

Hi Devik,

this could be asking too much, ave just finished compiling kernel with

htb

Quoted 1 line

patch, and the htb is functioning, do you mind giving me a sample config

I

Quoted 23 lines

can use to achieve this, if it aint too much of a bother.

which setup do u prefer:

Setup A

eth0 - Internet
eth1 - 20 LAN computers + 1 IP Telephony

Setup B

eth0 - Internet
eth1 - 20 LAN Computers
eth2 - 1 IP Telephony

Any choice u make is ok with me, I would just like to see your working sample HTB script.

Thanks

K

Quoted 12 lines

Don't expect good quality if use local QoS for incomming data. To have real non-best effort you need to have QoS on both sides of link - when transmitting packets. Then yes - HTB should be able to do it using priorities. But I doubd you can do it if IMQ is in the way. devik

Quoted 3 lines · Chijioke Kalu

Hello all,

Please, does anyone have a setup where HTB or IMQ was used to set

aside

Quoted 16 lines
Quoted 5 lines

uplink/downlink speed for IP Telephony, in other to have clear voice quality?

K

Quoted 10 lines

_________________________________________________________________
Add photos to your messages with MSN 8. Get 2 months FREE*.
http://join.msn.com/?pageþatures/featuredemail

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

Quoted 7 lines

_________________________________________________________________
STOP MORE SPAM with the new MSN 8 and get 2 months FREE*
http://join.msn.com/?pageþatures/junkmail

_________________________________________________________________
STOP MORE SPAM with the new MSN 8 and get 2 months FREE*
http://join.msn.com/?pageþatures/junkmail

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#3 lore raw
In reply to Chijioke Kalu

Yes if you consider transmission over internet. Unfortunately it is mostly best effort medium and workable VoIP is possible mainly because of huge BW after user's access line .. And there is still no compatible Diffserv marking working over whole Internet.

Quoted 45 lines · On Sat, 5 Jul 2003, Gerry Creager N5JXS wrote:

In fact, it's more complicated than Devik offers. QoS should be set, AND compatible marking taking place on both sides of the link as stated.
However, while it's extremely important that both participating
networks agree on marking and queuing, if the ISPs and carriers are congested and do not participate in mark recognition and appropriate queuing. it falls back to a best effort, lossy network, regardless of what you do at the edges.

gerry

Quoted 30 lines · Martin Devera

Don't expect good quality if use local QoS for incomming data. To have real non-best effort you need to have QoS on both sides of link - when transmitting packets. Then yes - HTB should be able to do it using priorities. But I doubd you can do it if IMQ is in the way. devik

Quoted 8 lines · Chijioke Kalu

Hello all,

Please, does anyone have a setup where HTB or IMQ was used to set aside uplink/downlink speed for IP Telephony, in other to have clear voice quality?

K

Quoted 10 lines

_________________________________________________________________
Add photos to your messages with MSN 8. Get 2 months FREE*.
http://join.msn.com/?pageþatures/featuredemail

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

Quoted 3 lines

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

Quoted 10 lines

--
Gerry Creager -- [email protected]
Network Engineering -- AATLT, Texas A&M University
Cell: 979.229.5301 Office: 979.458.4020 FAX: 979.847.8578
Page: 979.228.0173
Office: 903A Eller Bldg, TAMU, College Station, TX 77843

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/