Skip to contentSkip to conversation

qdisc on bridge?

LARTC Jon Zeeff 3 participants 3 messages Nov 26, 2003

lore
Share & tools
lore
#1 lore raw
Quoted 5 lines

I've set up bridging between two interfaces and this gives me a new "br0". When I apply qdiscs to it, what am I controlling - traffic out of eth1 or traffic headed out eth2?

Should I not be using br0 and refer to eth1 and eth2?

yes, this is true. Use eth1 and eth2 not br0.

Signature · 5 lines
Damjan Georgievski
jabberID: [email protected]
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
#2 lore raw
In reply to Jon Zeeff

Witaj Jon,

W Twoim liœcie datowanym 26 listopada 2003 (20:51:29) mo¿na przeczytaæ:

JZ> I've set up bridging between two interfaces and this gives me a new JZ> "br0". When I apply qdiscs to it, what am I controlling - traffic out of JZ> eth1 or traffic headed out eth2?

JZ> Should I not be using br0 and refer to eth1 and eth2?

just use eth1 and eth2 to control traffic not a virtual br0 device.

JZ> _______________________________________________
JZ> LARTC mailing list / [email protected]
JZ> http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

Signature · 6 lines
Pozdrowienia,
 Robert

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/