qdisc on bridge?
I've set up bridging between two interfaces and this gives me a new "br0". When I apply qdiscs to it, what am I controlling - traffic out of eth1 or traffic headed out eth2?
Should I not be using br0 and refer to eth1 and eth2?
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
Quoted 5 lines
I've set up bridging between two interfaces and this gives me a new "br0". When I apply qdiscs to it, what am I controlling - traffic out of eth1 or traffic headed out eth2?
Should I not be using br0 and refer to eth1 and eth2?
yes, this is true. Use eth1 and eth2 not br0.
Signature · 5 lines
Damjan Georgievski jabberID: [email protected] _______________________________________________ LARTC mailing list / [email protected] http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
Witaj Jon,
W Twoim liœcie datowanym 26 listopada 2003 (20:51:29) mo¿na przeczytaæ:
JZ> I've set up bridging between two interfaces and this gives me a new JZ> "br0". When I apply qdiscs to it, what am I controlling - traffic out of JZ> eth1 or traffic headed out eth2?
JZ> Should I not be using br0 and refer to eth1 and eth2?
just use eth1 and eth2 to control traffic not a virtual br0 device.
JZ> _______________________________________________
JZ> LARTC mailing list / [email protected]
JZ> http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
Signature · 6 lines
Pozdrowienia, Robert _______________________________________________ LARTC mailing list / [email protected] http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/