Enable HP machine to enable capture mute led and output mute led
A message that is not in the archive (sent off-list or not yet received): [email protected]
At Fri, 20 Jun 2014 15:55:58 +0800,
Quoted 5 lines · Kailang
Hi Takashi,
Maybe you don't receive.
I repost again.
Don't worry, it's been applied now. I've been off for a few days.
thanks,
Takashi
Quoted 43 lines
BR,
KailangQuoted 36 lines
Attach again.
It include below infomations.
Thanks.Quoted 32 lines
At Wed, 18 Jun 2014 17:13:57 +0800,
Quoted 11 lines · Kailang
Hi Takashi,
Attach was HP mute led support patch.
It use Line1 vref and Mic1 vref to control mute led for ALC282. Line1 vref to control output mute led.
Mic1 vref to control input mute led.It use GPIO3 and Mic1 vref to control mute led for ALC280. GPIO3 to control output mute led.
Mic1 vref to control input mute led.Could you include this kind of information in the patch changelog? The changelog text is way too short.
Quoted 6 lines
For the DMI string for output mute led application. I already request from HP to support it in next release.
HP_Mute_LED_0_A=> use Mic1 vref to control mute led. Is the string right?
I have tested upper string for Mic1 mute led.Yes, this has been working for some machines, AFAIK.
thanks,
Takashi
------Please consider the environment before printing this e-mail.
[2 0001-new-hp-mute-led.patch <application/octet-stream (quoted-printable)>]
Hi Takashi,
Our AE didn't tell me the ID is codec subsystem ID.
HP had some machine PCI subsystem ID and codec subsystem ID not the same. So, more machine will use one PCI subsystem ID.
Use codec subsystem ID to filter models.
BR,
Kailang
Quoted 58 lines
At Fri, 20 Jun 2014 15:55:58 +0800,
Quoted 5 lines · Kailang
Hi Takashi,
Maybe you don't receive.
I repost again.Don't worry, it's been applied now. I've been off for a few days.
thanks,
Takashi
Quoted 43 lines
BR,
KailangQuoted 36 lines
Attach again.
It include below infomations.
Thanks.Quoted 32 lines
At Wed, 18 Jun 2014 17:13:57 +0800,
Quoted 11 lines · Kailang
Hi Takashi,
Attach was HP mute led support patch.
It use Line1 vref and Mic1 vref to control mute led for ALC282. Line1 vref to control output mute led.
Mic1 vref to control input mute led.It use GPIO3 and Mic1 vref to control mute led for ALC280. GPIO3 to control output mute led.
Mic1 vref to control input mute led.Could you include this kind of information in the patch changelog? The changelog text is way too short.
Quoted 6 lines
For the DMI string for output mute led application. I already request from HP to support it in next release.
HP_Mute_LED_0_A=> use Mic1 vref to control mute led. Is the string right?
I have tested upper string for Mic1 mute led.Yes, this has been working for some machines, AFAIK.
thanks,
Takashi
------Please consider the environment before printing this e-mail.
[2 0001-new-hp-mute-led.patch <application/octet-stream (quoted-printable)>]