Add eSDHC UHS-I/HS200 mode support for ls1012a/ls1046a/ls208xa
Get series with b4
b4 am 20170512004641.GB8471@dragonVersions newest first · linked by author and title
- v3 Latest0 of 5 patches 0 repliesNew
- v12 of 3 patches 0 repliesSuperseded
Patches in v3 No applies recorded yet
None of the 5 patches the cover letter announces are in this archive.
Reviews trailers per patch
No Reviewed-by, Acked-by or Tested-by trailers for v3 yet.
Cover letter [v3, 0/5] Add eSDHC UHS-I/HS200 mode support for ls1012a/ls1046a/ls208xa
Quoted 14 lines · Yangbo Lu
This patchset is to add eSDHC UHS-I/HS200 mode support for ls1012a/ls1046a/ls208xa. Also add eSDHC node for ls1088a. Because eSDHC is not a standard SD controller, the specific speed mode support depends on board's peripheral circuit for eSDHC. So, we have to add these speed modes support on board dts file.
In additon, these dts patches depends on esdhc driver patches which just had been merged on mmc.git. Otherwise, the UHS-I SD card and eMMC HS200 card would fail to be initialized, but other cards still could work fine.
https://patchwork.kernel.org/patch/9689875/
https://patchwork.kernel.org/patch/9689877/
https://patchwork.kernel.org/patch/9689879/
https://patchwork.kernel.org/patch/9689887/
https://patchwork.kernel.org/patch/9689885/
Quoted 6 lines
Yangbo Lu (5):
mmc: dt: add compatible into eSDHC required properties
arm64: dts: ls1046a: support SD UHS-I and eMMC HS200 on RDB
arm64: dts: ls208xa: support SD UHS-I on RDB and eMMC HS200 on QDS
arm64: dts: ls1012a: add eSDHC nodes
arm64: dts: ls1088a: add esdhc node
Applied all, thanks.