arm64: dts: renesas: Add Support for R-Car D3 and Draak
Get series with b4
b4 am [email protected]Versions newest first
- v1 Latest0 of 4 patches 0 repliesNew
Patches in v1 No applies recorded yet
None of the 4 patches the cover letter announces are in this archive.
Reviews trailers per patch
No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.
Cover letter [PATCH 0/4] arm64: dts: renesas: Add Support for R-Car D3 and Draak
Quoted 23 lines · Simon Horman
Quoted 13 lines · Geert Uytterhoeven
Hi Simon, Magnus,
This patch series adds minimal support for the R-Car D3 SoC and the Draak development board, allowing to boot from a ramdisk using a serial console.
- The first two patches add DT sources for R-Car D3 and Draak. Due to the use of hardcoded constants, they have no further (build) dependencies (obviously there is a runtime dependency).
- The last two patches replace the hardcoded constants by symbols from DT binding headers, and thus depend on those headers. Hence it should be postponed to v4.15.Quoted 2 lines
For proper operation, this depends on the 3 series I have just sent:
- [PATCH 0/3] arm64: renesas: Base R-Car D3 support,I have applied the above patchset for v4.14.
Quoted 1 line
- [PATCH 0/4] soc: renesas: Add R-Car D3 support,
And this one too.
Quoted 8 lines
Quoted 1 line
- [PATCH 0/4] clk: renesas: Add R-Car D3 support.
And this one seems to have been acked, so I assume you will apply it once you are back from holidays.
So I have applied the first two patches for v4.14.
Please repost the remaining two after v4.13-rc6 at which time I should be able to queue them up for v4.15.
I have now done so.