Skip to content

EDAC/altera: Check previous DDR DBE during driver probe

[email protected] linux-edac lkml 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v1 Latest2 patches 0 repliesNew

Patches in v1 No applies recorded yet

#Subject and filesSizeRepliesApplied
1/2firmware: stratix10-svc: Add command to get SEU error infoinclude/linux/firmware/intel/stratix10-smc.h+20 -00 replies
2/2EDAC/altera: Check previous DDR DBE during driver probedrivers/edac/altera_edac.c+24 -50 replies

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.

Read the v1 thread

Cover letter [PATCH 0/2] EDAC/altera: Check previous DDR DBE during driver probe

From: Niravkumar L Rabara <[email protected]>

Starting from SoCFPGA Agilex7, new SDM mailbox command is introduced to read Single Event Update Error information, SEU detects both corrected and uncorrected error.

If the previous HPS reboot caused by the DDR double bit error, bit-31 is set high of boot scratch register 8. EDAC driver probe will check this bit status and sends the SMC command to Arm Trusted Firmware. Firmware will send mailbox command to SDM to get the SEU error information and pass it to EDAC driver, driver will print error count, sector address and error data for previous DDR DBE.

Niravkumar L Rabara (2):
firmware: stratix10-svc: Add command to get SEU error info EDAC/altera: Check previous DDR DBE during driver probe

 drivers/edac/altera_edac.c                   | 29 ++++++++++++++++----
 include/linux/firmware/intel/stratix10-smc.h | 20 ++++++++++++++
 2 files changed, 44 insertions(+), 5 deletions(-)
Signature · 1 line
2.25.1