Skip to content

i.mx: add the initial i.mx6q core/board support

Stefano Babic u-boot 1 version New

Get series with b4
b4 am [email protected]

Versions newest first

  1. v3 Latest0 of 5 patches 0 repliesNew

Patches in v3 No applies recorded yet

None of the 5 patches the cover letter announces are in this archive.

Reviews trailers per patch

No Reviewed-by, Acked-by or Tested-by trailers for v3 yet.

Read the v3 thread

Cover letter [U-Boot] [PATCH V3 0/5] i.mx: add the initial i.mx6q core/board support
Quoted 11 lines · Jason Liu

This patch-set add the initial support for freescale i.mx6q support. freescale i.mx6q is a quad core built on arm cortex_a9 complex.

The patch-set has been tested ok on freescale i.mx6q Armadillo2 board and also make sure it does not break i.mx5 support

The v1 patch-set has also been tested Ok by: Dirk Behme

Tested-by Dirk Behme <[email protected]>

The patch-set is based on Stefano's uart clean up patch:
http://patchwork.ozlabs.org/patch/127115/

Jason,

I have no open issues with your patches. I have applied them (at the moment) to u-boot-imx, next branch.

I know that the patches were sent after the patches window was closed. However, they do not introduce so big changes to current IMX code, as MX5 did in the past, and I will not be against to merge them into the master branch in the next pull request, if nobody complains about it.

Best regards,
Stefano babic

Signature · 5 lines
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================

Read the cover letter in its thread